Memory Module Specification
T E C H N O L O G Y
KHX1800C9D3LK2/4GX
4GB (2GB 256M x 64-Bit x 2 pcs.) DDR3-1800 CL9 240-Pin DIMM Kit
DESCRIPTION:
Kingston's KHX1800C9D3LK2/4GX is a kit of two 256M x 64-bit (2GB) DDR3-1800 CL9 SDRAM (Synchronous DRAM) low voltage memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per module. Total kit capacity is 4GB. Each module kit supports Intel® XMP (Extreme Memory Profiles). Each module kit has been tested to run at DDR3-1600 CL9-9-9-27 at 1.35V (Profile #1) and DDR3-1800 CL9-9-9-27 at 1.35V
(Profile #2). The SPDs are programmed to JEDEC standard latency DDR3-1333Mhz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The JEDEC standard electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply VDDQ = 1.5V ± 0.075V 667MHz fCK for 1333Mb/sec/pin
8 independent internal bank Programmable CAS Latency: 6,7,8,9
Posted CAS Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 7(DDR3-1333) 8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component
PERFORMANCE:
|
CL(IDD) |
9 cycles |
|
||
|
Row Cycle Time (tRCmin) |
49.5ns (min.) |
|
||
|
Refresh to Active/Refresh Command Time (tRFCmin) |
110ns |
|
||
|
Row Active Time (tRASmin) |
36ns (min.) |
|
||
|
Power (operating per module) |
2.160 W (DDR3-1333 @ standard 1.5V) |
|
||
|
UL Rating |
94 V - 0 |
|
||
|
Operating Temperature |
0o C to 85o C |
|
||
|
Storage Temperature |
-55o C to +100o C |
|
Document No. 4805558-001.A00 |
04/13/10 |
Page 1 |
Kingston
MODULE DIMENSIONS:
T E C H N O L O G Y
30.00 |
Units: millimeters |
133.35 |
|
||
|
|
18.80
15.80
11.00
8.00
0.00
0.00 |
54.70 |
w/ heatsink assembly
Document No. 4805558-001.A00 |
Page 2 |