Kingston KHX1333C9D3UK24GX User Manual

TECHNOLOGY
Memory Module Specification
KHX1333C9D3UK2/4GX
4GB (2GB 256M x 64-Bit x 2 pcs.) DDR3-1333
CL9 240-Pin DIMM Kit
Kingston's KHX1333C9D3UK2/4GX is a kit of two 256M x 64-bit 2GB (2048MB) DDR3-1333 CL9 SDRAM (Synchronous DRAM) ultra low voltage memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per module. Total kit capacity is 4GB. Each module kit supports module kit has been tested to run at DDR3-1333 CL9-9-9 at 1.25V (Profile #1). The SPDs are programmed to JEDEC standard latency DDR3-1333Mhz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The JEDEC standard electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply VDDQ = 1.5V ± 0.075V 667MHz fCK for 1333Mb/sec/pin 8 independent internal bank Programmable CAS Latency: 6,7,8,9 Posted CAS Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 7(DDR3-1333) 8-bit pre-fetch Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component
Intel® XMP (Extreme Memory Profiles). Each
Keyed
Y
G
O
L
O
N
H
C
E
T
PERFORMANCE:
CL(IDD) 9 cycles Row Cycle Time (tRCmin) 49.5ns (min.) Refresh to Active/Refresh Command Time (tRFCmin) 110ns Row Active Time (tRASmin) 36ns (min.) Power (operating per module) 2.160 W (DDR3-1333 @ standard 1.5V) UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C
Document No. 4805500-001.B00
04/05/10
Page 1
MODULE DIMENSIONS:
TECHNO L O GY
Kingston
30.00
18.80
15.80
11.00
8.00
0.00
Units: millimeters
0.00
w/ heatsink assembly
133.35
54.70
Keyed
TECHNO L O GY
Document No. 4805500-001.B00 Page 2
Loading...