kingston KHX1333C9D3B1K2-8G User Manual

Memory Module Speciﬁ cations

KHX1333C9D3B1K2/8G

8GB (4GB 512M x 64-Bit x 2 pcs.) DDR3-1333 CL9 240-Pin DIMM Kit

SPECIFICATIONS

CL(IDD) 9 cycles Row Cycle Time (tRCmin) 49.5ns (min.) Refresh to Active/Refresh 160ns (min.)

Command Time (tRFCmin) Row Active Time (tRASmin) 36ns (min.) Power (Operating) 1.410 W*

UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C

*Power will vary depending on the SDRAM used.

DESCRIPTION

Kingston's KHX1333C9D3B1K2/8G is a kit of two 512M x 64-bit (4GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8 memory modules, based on sixteen 256M x 8-bit FBGA components per module. Total kit capacity is 8GB. The SPD's are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers. The JEDEC electrical and mechanical specifications are as follows:

FEATURES

• JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 667MHz fCK for 1333Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE

< 95°C

• Asynchronous Reset

• PCB : Height 1.180” (30.00mm), double sided component

Continued >>

Document No. 4805877-001.C00 09/30/11 Page 1

continued HyperX

MODULE DIMENSIONS

TECHNOLOGY

30.00

18.80

15.80

11.00

8.00

0.00

Units: millimeters

0.00

54.70

MODULE WITH HEAT SPREADER

133.35

FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

Document No. 4805877-001.C00 Page 2