Kingsman OFP42N, OFP42LP, OFP42NS, OFP42LPS Operation And Installation Manual

OUTDOOR FIREPLACE MANUAL

Models: OFP42N, OFP42LP, OFP42NS, OFP42LPS

Certified For USA & Canada

Standards: CSA 4.96 US 2nd Edition, CGA CR97-003, CGA 2.17-M91

Outdoor Gas Fireplaces

Owner’s Operation and Installation Manual

Installer: Leave this manual with the appliance.

Consumer: Retain this manual for future reference

IMPORTANT: Read all instructions

carefully before starting installation.
Failure to follow these installation
instructions may result in a possible
fire hazard and will void the warranty.

Warning

If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury, or
loss of life.

-Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.

-An LP-cylinder not connected for use shall not be stored in the
vicinity or this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your

building.

• Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

-Installation and service must be performed by a qualified installer,
service agency, or the gas supplier.

This manual must be used for installation and retained by the homeowner for
operation and maintenance. Save this manual for future reference. Please contact
your dealer for any questions or concerns.

2340 Logan Ave., Winnipeg, MB, Canada, Phone: [phone] –Printed in Canada- PART #42OFP-MAN Oct. 10/08

Improper installation,
adjustment, alteration,
service, or maintenance
can cause injury or
property damage. Read
the installation, operating
and maintenance
instructions thoroughly
before installing or
servicing this equipment.

DO NOT LEAVE
FIREPLACE
UNATTENDED WHEN
IN USE

FOR OUTDOOR USE

DO NOT USE FOR

COOKING.

The OFP42N and OFP42LP
Fireplace are to be used only
with the Logs/Rock Kits as
specified in this manual. Do
not burn wood or other
materials in this appliance.

Warning

Warning

Warning

ONLY.

Warning

Warning

Table of Contents

SECTION PAGE

Table of Contents…………………………………………………………………………………………. 2

Introduction………………………………………………………………………………………………… 3

Pre-Installation Questions and Answers……………………………………………………………….. 4

Fireplace Dimensions and Framing Specifications………………………………………………........ 5

Installation Clearances……………………………………………………………………………..…….. 6

Screened Porch Installation……………………………………………………………………………… 6

Gas Line Installation and Gas Specifications……………………………………………………......... 7

Brick Panel Installation …………………………………………………………………….…………….. 8

Curtain and Hood Installation………………………………………………………………..…….…….. 8

Installing Stainless Steel Surround……………………………………………………………………… 9

Log Placement…………………………………………………………………………………….………. 10

MQ Rock Setup…………………………………………………………………………………………… 11

MQ Rock and Glass Setup…………………………………………………………….………………… 12

Lighting Instructions…………………….………………………………………………………………… 13

Gas Conversion -Valve-……………………………….………………………………………………… 14

Gas Conversion –Burner and Pilot-..…………………………………………………………………… 15

Troubleshooting…………………………………………………………………………………………… 16

Cleaning……………………………………………………………………………………………………. 16

Electronic Spark Assist…………………………………………………………………………………… 17

Weather Cover Installation………………………………………………………………………………. 18

Parts List …………………………………………………………………………………………………... 19

Warranty…………………………………………………………………………………………………… 20

2

OFP42N/OFP42LP Introduction

Models OFP42N/OFP42LP are for outdoor use only.
This appliance MUST NOT be used for cooking.

WARNING: This appliance shall be used ONLY
outdoors in a well-ventilated space and shall NOT be
used inside a building, garage, or any other enclosed
area.

WARNING: THIS UNIT IS NOT FOR USE WITH SOLID
FUEL.

The installation must conform with local codes or in the
absence of local codes, to the National Fuel Gas Code
ANSI Z223.1/NFPA 54, the Natural Gas and Propane
Installation Code, CSA B149.1, or International Fuel Gas
Code.

The appliance and its individual shut off valve must be
disconnected from the gas supply piping system during
any pressure testing of the system at test pressures in
excess of ½ psi (3.5 kPa).

The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than ½
psi (3.5 kPa).

For the state of Massachusetts a T-handle gas shut-off valve must be
used on a gas appliance. This T-handle gas shut-off valve must be
listed and approved by the state of Massachusetts.

This is in reference to the State of Massachusetts state code

Always keep the appliance clear and free from
combustible materials, gasoline, and other flammable
vapors and liquids.

Do not locate appliance where it can

get excessively wet. Do not use this
appliance if any part has been under
water. Immediately call a qualified
service technician to inspect the unit
and to replace any part of the control
system and any gas control which
gas been under water.

• Children and adults should be alerted to the

hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.

• Young children should be carefully supervised
when they are in the area of the appliance.

CMR238.

Warning

• Clothing or other flammable materials should not

be hung from the appliance or placed on or near
the appliance.

• Any guard or other protective device removed for

servicing the appliance must be replaced prior to
operating the appliance.

• Installation and repair should be done by a

qualified service person. The appliance should be
inspected by a qualified service person. More
frequent cleaning may be required as necessary. It
is imperative that control compartment, burners
and circulating air passageways of the appliance
be kept clean.

• Inspect the fuel supply connection (including the

hose for LP models) before each use of the
appliance. See p11-Lighting Instructions for
removal of Access Panel.

• If it is evident there is excessive abrasion or wear,

or the hose is damaged, it must be replaced prior
to the appliance being put into operation.

• The LP gas supply cylinder used with LP models

must be constructed and marked in accordance
with the Specifications for LP-Gas Cylinders of the
US Department of Transportation (D.O.T.), or the

Standard for Cylinders, Spheres, and Tubes for
Transportation of Dangerous Goods and
Commission, CAN/CSA-B339* as applicable.

• Cylinders must be stored outdoors in a well

ventilated area out of the reach of children.
Disconnected cylinders must have threaded valve
plugs tightly installed and must not be stored in a
building, garage or any other enclosed area.

• Storage of this appliance indoors is permissible

only if it has been disconnected from its fuel
supply (natural gas line or LP gas cylinder).

• The LP gas cylinder supply system must be

arranged for vapor withdraws.

• The LP gas cylinder used must include a collar to

protect the cylinder valve.

• When an LP model is not in use, the LP gas must

be turned off at the supply cylinder.

3

OFP42N/OFP42LP Pre-Installation Questions and Answers

4

OFP42N/OFP42LP Framing Specifications

-Fireplace and Framing Dimensions-

*Attention: Top & Rear Standoffs must be folded into position & fastened with Screws before installation.

(Dimensions allow for ½” in front of framing tabs for finishing materials.)

Framing Clearances to Fireplace and Standoffs(Unless otherwise noted): Bottom: 0”/ Sides: 0” /

Adjacent side wall: 3-1/2” /Floor of fireplace to ceiling: 7’ /Low Profile Enclosure: 43-1/2”Minimum. Back: 0” /
Top: 0”.

5

,

OFP42N/OFP42LP Installation Clearances

Mantel Clearances

Notice

A qualified service person must install
firebox. Follow all local codes.

Warning

Improper installation,
adjustment, alteration, service, or
maintenance can cause injury or
property damage. Read the
installation, operating and
maintenance instructions
thoroughly before installing or
servicing this equipment.

Installation Clearances

Carefully follow the instructions below. This will ensure safe
installation.

Minimum Clearances- Side Walls

Minimum Wall and Ceiling Clearances

A. Clearances from the firebox to adjacent wall should not

be less than 3-1/2 inches.

B. Clearance from the top of the fireplace front to the ceiling

should not be less than 47 inches.

C. Clearance from the bottom of the firebox to the floor is 0

inches.

D. Clearance from the side of the fireplace to the enclosure

is 0 inches.

E. Clearance from the top of the fireplace standoffs is 0

inches.

Warning

Ensure the minimum clearances shown are maintained.

Left and right clearances are determined when facing the

Warning

Maintain the minimum clearances. If you can, provide greater

clearances from the floor

ceiling, and adjoining wall.

OFP42N / OFP42LP Screened Porch Installation

Minimum porch area………………………..….….. 96sq. feet

Minimum ceiling height ……………………….…….92” inches

A minimum of two (2) walls can be screened, but must be open to outside ventilation, with a minimum screen area of 64

sq. feet, and a minimum side wall height of 78” inches.

The OFP42N and OFP42LP can be installed safely in a screened porch area within the following guidelines:

6