King of Fans 82820 User Manual [en, es]

1 year Limited Warranty (please see inside for details)

HIGH VELOCITY AIR CIRCULATOR

MODEL: HV-20G

UL#E144918

OWNER’S MANUAL

READ & SAVE THESE INSTRUCTIONS

HIGH VELOCITY AIR CIRCULATOR

ASSEMBLY AND OPERATING INSTRUCTIONS

CAUTION: Read and follow all instructions before operating fan. Do not use fan if

any part is damaged or missing.

WARNING: To reduce the risk of fire or electrical shock, DO NOT use this fan with
any solid state speed control device. This appliance has a 3-prong grounded plug
that must be inserted into a matching outlet. To reduce the risk of electrical shock,
this grounding plug must not be removed from the plug. Where a t wo-prong wall
outlet is encountered, it must be replaced: contact a qualified electrician. DO NOT
attempt to remove this safety feature. Use your fan only with adequate wiring that is
up to Code. Connect to properly grounded outlets only.

RULES FOR SAFE OPERATION:

● Always unplug unit for cleaning.

● Always unplug unit when not in use.

● Always unplug when moving unit from one location to another.

● Do not place foreign objects through guard when fan is in operation.

● Do not operate without fan guards properly locked.

● Do not use this fan with an extension cord.

● Do not use fan in window. Rain and moisture may create an electrical hazard.

● Do not place fan or fan parts near an open flame, cooking or other heating

appliance.

● Do not operate this unit with a damaged cord or plug, especially when this unit
has previously malfunctioned, or been dropped or damaged.

● Make sure fan is on a stable, flat surface when in operation.

● Close supervision is necessary when this unit is used by or near children.

UNPACK YOUR FAN AND CHECK THE CONTENTS

● Fan Head With Knobs

● Break Down Stand Assembly

● Wall Bracket

● Owner’s Manual

ASSEMBLY INSTRUCTIONS

1. Please put the fan body on a flat and stable surface

as shown in the picture.

2. Remove the two screws from the steel tube
attached to the fan head, save them for step 4.

3. Align the hole in the stand with the hole in the

steel tube attached to the fan head.

4. Loosen the adjustment knobs at the side of

the fan body just slightly to make the
attached steel tube pivot, carefully Insert
the ends of the stand into the counterparts
and align the holes.

5. Carefully insert the screws from step 2 into

the holes and tighten. Please be sure to
re-tighten the adjustment knobs loosened in
step 3 to avoid swaying of the fan head.