KING Jack OA8400, OA8401 Owner's Manual
Low Prole Digital HDTV Over-the-Air Antenna
Owner’s Manual
Roof Thickness: 1” to 4-1/2”
Roof Thickness: 4-1/2” to 8”
(when installed with KING extension #21850)
OA8400 • White
OPERATION and AIMING THE ANTENNA ............................................................1
CONTENTS and EXTENSION INSTALLATION ......................................................2
EXTERIOR BASE MOUNT INSTALLATION ...........................................................3
INTERIOR ENCLOSURE INSTALLATION .............................................................4
POWER INJECTOR INSTALLATION ......................................................................5
LIMITED WARRANTY .............................................................................................6
NOTE: Please read thru the installation instructions before beginning.
See page 2 for items supplied by the installer.
See page 5 for information on the MB8200 Mounting Plate and KING SureLock Signal Meter.
SPECIFICATIONS
Dimensions: 8.9” H x 16” W x 12” L
Weight: 2.4 lbs.
Frequency Bands: VHF (54-216 Mhz)
UHF (470-698 Mhz)
FM (87.9-107.9 Mhz)
OA8401 • Black
CONTENTS
Powered Amplier: +12 Volt / 100 mA
Power Supply: KING Power Injector (included)
Enclosure/Mount: ASA-Automotive grade
Thank you for choosing a KING Antenna!
OPERATION
AIMING THE ANTENNA
1. Turn on TV and power injector.
NOTE: In steps 2-6, keep track of the knob position
where you receive the most channels.
2. Press button and rotate the antenna all of the
2
way in one direction until it hits the stop.
3. Perform a channel scan per the digital TV or digital TV
converter box manufacturer’s instructions.
Note the number of channels received.
4. Press button and rotate antenna 90 degrees. Scan again.
4
Note the number of channels received.
5. Press button and rotate antenna 90 degrees. Scan again.
5
Note the number of channels received.
6. Press button and rotate antenna 90 degrees. Scan again.
6
Note the number of channels received.
7. Reposition your KING Jack antenna to where you received the most channels.
Choose one of those channels on your TV.
Now monitor the signal strength screen and ne tune the KING Jack
until the highest signal strength is achieved. Perform one nal scan.
2
4
5
6
8. Watch TV!
Page 1
CONTENTS
IMPORTANT!
For roofs 4-1/2” to 8”
thick, install
KING extension #21850.
IMPORTANT!
You must install
the included
wall mount
power injector
to operate the
KING Jack
antenna
(see page 5).
EXTENSION INSTALLATION
ROOFS 4 1/2” to 8” THICK ONLY!
Roofs thinner than 4 1/2” go to next page.
If your roof is 4-1/2” to 8” thick
you will need to install KING extension #21850.
If using the extension, install it now,
BEFORE INSTALLING BASE MOUNT ON ROOF.
• Remove the existing adjustable connector from the upper
connector located in the base mount.
• Extension only ts onto upper connector one way. Line up
as shown at right and engage the extension onto the upper
connector.
• Leave extension sticking out of base mount more than the
thickness of the roof.
Page 2
Loading...