King-Gage ES2 550*-1 Series Installation And Operation Instructions Manual

ES2 Electronic Liquid Level Transmitter EX-1832Effective: August, 2004 EX-1832

®

KING-GAGE

4-20 mA Remote Liquid Level Transmitter

ES2

Remote Liquid Level Transmitter
Model 550*-1-** w/Cable
and Junction Enclosure

Installation and
Operation Instructions

Page 1

ES2 Electronic Liquid Level Transmitter EX-1832

© 2004 King Engineering Corporation. All rights reserved.

The information contained in this manual was accurate at
the time of release. Specifications are subject to change
without notice.

Warranty - All King Engineering products are guaranteed
to be free from defects in material and workmanship for
one year from the date of purchase. Any product or part
found to be defective under normal use within one year of
purchase will be repaired or replaced at no charge if
returned to the company at Ann Arbor, Michigan within
ten days of discovery of the defect. No other warranties,
whether expressed, implied or statutory, including the
warranties of fitness for a particular purpose or merchanta­bility, are given by this agreement.
The exclusive remedy for nonconformity of these goods
shall be repair and/or replacement of the nonconforming
goods or parts.

Seller will not be liable for consequential damages resulting
from breach of this agreement. The term “consequential
damages” shall include but shall not be limited to damage
to all machines, equipment and goods other than the
goods sold hereby, interruption of production, loss of
profits, delays of any kind, administrative expense, and
overhead.

Revisions:

(A) August, 2004 - Original Release

Page 2

ES2 Electronic Liquid Level Transmitter EX-1832

KING-GAGE ES2 Level Transmitter

Two-wire sensor/transmitter provides a direct 4-20 mAdc
analog electronic output signal. Fixed-range transmitter is
designed specifically for hydrostatic pressure measurement
for liquid level gauging.

Transmitter package includes 15 feet of cable and corro­sion-resistant Signal Junction Enclosure. (This enclosure
also houses the external zero adjustments and signal loop
connection terminals.)

Model No. Designations

55xx-1-xx

Pressure Range

05 ............... 0-5 psig

10 ............... 0-10 psig

15 ............... 0-15 psig

30 ............... 0-30 psig

50 ............... 0-50 psig

Configuration (Housing)

01 ..... Short Mount

02 ..... Standard Mount

03 ..... Long Mount

Range Designation

A model number/range designation is listed on the end of
the transmitter housing. The last two digits of the model
number actually refer to the transmitter range. As an
example, MODEL 5502-1-10 is a 0-10 psig range,
standard mount transmitter.

Insulated

Tank Wall

Clamp Nut

MODEL/RANGE

5701-1-15 PSIG

Flush-Weld
Tank Shell

Junction

Enclosure

KING-GAGE

Electronic

4-20 mA

Sensor

®

Page 3