King Canopy CarryPak
Please read instructions completely before setting up your instant canopy.
SAFETY AND CARE INFORMATION
1 Always use common sense.
2 Do not use your canopy as a permanent cover.
3 It is designed for temporary use only. Damages due to
weather conditions are not warranted.
4 Do not set up on a steep incline. Do not leave unattended.
5 Never set up in windy, rainy, or snowy conditions. Canopy is
not intended to serve as protection from such conditions.
Use for shade only. Disassemble and properly store your
Canopy after each use.
6 Do not let snow or rain accumulate on top. It will collapse.
7 Always us an anchoring system. Your canopy will take ight in
windy conditions. Anchoring is your responsibility. Damage
due to weather conditions are not warranted.
8 Keep your canopy away from all re sources, such as grills or
re pits.
CarryPak Instant Canopy
8’x8’
9 Do not machine wash your top. Wash with mild soap and
water with a brush while the Instant Canopy is open without
the legs extended. Do not use harsh detergents, abrasives or
bleach.
10 Do not put your Instant Canopy away while wet or damp.
This promotes mildew and rust. Always store completely dry.
11 For best results in keeping your top clean and to avoid small
rips and tears, it is recommended that the top be removed
and stored in the carry bag after each use.
12 Never leave your canopy unattended!
WARNING!
Keep all ame and heat sources away from this tent fabric. This
tent is made with fabric that meets CPAI-84 specications for ame
resistance. It is not re proof. The fabric will burn if left in continuous
contact with any ame source.
King Canopy Brand Products
1730 Five Points Lane Fuquay-Varina, NC 27526
Phone: 1-800-800-6296 • www.kingcanopy.com
SET UP & SAFETY
INSTRUCTIONS
SET UP TAKE DOWN
1. Remove canopy from Backpack and place it
feet down where you are setting it up.
2. Pull the opposite corners outwards to
expand canopy.
3. Slide the corner brackets up on all four
corners until the pins lock in place.
4. Drape the top over the frame and attach
the hook and loop tape at each corner.
1. Starting with the lowest leg section, release
and push in each section of the legs to their
innermost point.
2. Remove canopy top and half wall, fold them
up so they t in the back pack but do not
put them in the back pack yet.
3. Release the corner brackets by pulling the rings
out to allow the frame to close.
4. After all corners are released, pick up one corner and
walk inward towards the opposite corner to close unit.
5. Extend the canopy legs out to desired height,
beginning with the lower (rst) section and
pull out each section one by one.
6. Attach the half wall by fastening the hook & loop tape..
5. Fully close (compress) frame and slide into back pack.
Make sure to shake o all dirt, sand and clean o the frame
if possibe to keep inside of back pack clean and the legs of
your canopy from sticking when setting up again.
Loading...