King Canada RC-110, RC-220 Instructions Manual

REMOTE POWER CONTROL

SYSTEMS

WARRANTY INFORMATION

PROOF OF PURCHASE

Please keep your dated proof of purchase for warranty and servicing purposes.

REPLACEMENT PARTS

Replacement parts for this product are available at our authorized King Canada service
centers across Canada.

INSTRUCTIONS

RC-110

(110V,

1 phase only)

RC-220

,

(220V

1 phase only)

LIMITED TOOL WARRANTY

King Canada makes every effort to ensure that this product meets high quality and
durability standards. King Canada warrants to the original retail consumer a 2-year limited
warranty as of the date the product was purchased at retail and that each product is free
from defects in materials. Warranty does not apply to defects due directly or indirectly to
misuse, abuse, normal wear and tear, negligence or accidents, repairs done by an
unauthorized service center, alterations and lack of maintenance. King Canada shall in no
event be liable for death, injuries to persons or property or for incidental, special or
consequential damages arising from the use of our products.

To take advantage of this limited warranty, return the product at your expense together with
your dated proof of purshase to an authorized King Canada service center. Contact your
retailer or visit our web site at www.kingcanada.com for an updated listing of our
authorized service centers. In cooperation with our authorized serviced center, King
Canada will either repair or replace the product if any part or parts covered under this
warranty which examination proves to be defective in workmanship or material during the

warranty period.

KING CANADA INC. DORVAL, QUÉBEC, CANADA H9P 2Y4

www.kingcanada.com

COPYRIGHT © 2007 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.

SET-UP AND OPERATION

These remote power control systems should be used for remotely turning on and off 110V
(RC-110) and 220V (RC-220) dust collectors.

RC-110 Power ................................110V, 15 Amp., single phase only

RC-220 Power ..............................220V, 15 Amp., single phase

Remote control type................................................................Infrared

Receiving angle ............................................................................120

Use ..................................................................................Indoors only

Electrical warning! Connect to an outlet rated at least 20 amps, on a circuit
protected by a 20 amp circuit breaker or fuse.

Mounting

A remote power control can be mounted to the dust collector by drilling four holes into the
side of the motor bracket, then use the supplied mounting hardware to secure it in place.

ou can also mount the remote power control to a wall next to your dust collector.

Y

Turning the RC-110 or RC-220 On & Off

The remote power controls can be operated from the system panel (A) Fig.1 or the remote
control (B). Plug the dust collector plug into the receptacle (C), connect the remote power
control power cord to an appropriate power source, the switch of the dust collector must
be in the “On” position and finally press the “On” button (A-1).
operate until the “Off” button (A-2) is pressed.

Using the Timer feature

Once the dust collector is running, press the “Timer” button (A-3), everytime you press the
timer button the display number will increase by one minute and can be set up to 99
minutes. Hold the timer button to scroll quickly up towards 99 minutes, going past 99,
minutes will restart the minute count at zero (00). The dust collector will operate for the
amount of time set on the timer, once the zero (00) count is reached, the dust collector will
automatically stop. If you press the “Of
collector will turn off and the timer will be reset to zero (00).

f” button while the timer is engaged, the dust

only

0

The dust collector will

Figure 1