KINGBRIGHT L-7104PBC User Manual

T-1 (3mm) SOLID STATE LAMP

ATTENTION

OBSERVE PRECAUTIONS

FOR HANDLING

ELECTROSTATIC

DISCHARGE

SENSITIVE

DEVICES

Features



LOW POWER CONSUMPTION.



POPULAR T-1 DIAMETER PACKAGE.



GENERAL PURPOSE LEADS.



RELIABLE AND RUGGED.



LONG LIFE - SOLID STATE RELIABILITY.



AVAILABLE ON TAPE AND REEL.



RoHS COMPLIANT.

P/N: L-7104PBC BLUE

Description

The Blue source color devices are made with InGaN on
SiC Light Emitting Diode.
Static electricity and surge damage the LEDS.
It is recommended to use a wrist band or anti-electrostatic
glove when handling the LEDs.
All devices, equipment and machinery must be electrically
grounded.

Package Dimensions

Notes:

1. All dimensions are in millimeters (inches).

2. Tolerance is ±0.25(0.01") unless otherwise noted.

3. Lead spacing is measured where the leads emerge from the package.

4. Specifications are subject to change without notice.

SPEC NO: DSAB0171 REV NO: V.8 DATE: NOV/19/2005 PAGE: 1 OF 3
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU

Selection Guide

Viewing

Iv (mcd)

Part No. Dice Lens Type

@ 20mA

Min. Typ.

L-7104PBC BLUE (InGaN) WATER CLEAR

Note:

θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.

1.

180 450

Electrical / Optical Characteristics at TA=25°C

Symbol Parameter Device Typ. Max. Test ConditionsUnits

λpeak

λD

∆λ1/2

C Capacitance Blue 65 pF VF=0V;f=1MHz

Peak Wavelength Blue 468 nm IF=20mA

Dominant Wavelength Blue 470 nm IF=20mA

Spectral Line Half-width Blue 25 nm IF=20mA

Angle

2θθθθ1/2

20°

VF Forward Voltage Blue 3.65 4.2 V IF=20mA

IR Reverse Current Blue 10 uA VR = 5V

Absolute Maximum Ratings at TA=25°C

Parameter Blue Units

Power dissipation 102 mW
DC Forward Current 30 mA
Peak Forward Current [1] 160 mA
Reverse Voltage 5 V
Operating / Storage Temperature -40°C To +85°C
Lead Solder Temperature [2] 260°C For 3 Seconds
Lead Solder Temperature [3] 260°C For 5 Seconds

Notes:

1. 1/10 Duty Cycle, 0.1ms Pulse Width.

2. 2mm below package base.

3. 5mm below package base.

SPEC NO: DSAB0171 REV NO: V.8 DATE: NOV/19/2005 PAGE: 2 OF 3
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU