Page 1
5.0X6.0mm SURFACE MOUNT LED LAMP
AA5060SYC/E SUPER BRIGHT YELLOW
Features
SINGLE COLOR.
SUITABLE FOR ALL SMT ASSEMBLY AND SOLDER
PROCESS.
AVAILABLE ON TAPE AND REEL.
IDEAL FOR BACKLIGHTING.
PACKAGE : 500PCS / REEL.
RoHS COMPLIANT.
Package Dimensions
Description
The Super Bright Yellow source color devices are made with
DH InGaAlP on GaAs substrate Light Emitting Diode.
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25(0.01") unless otherwise noted.
3. Specifications are subject to change without notice.
SPEC NO: DSAD0900 REV NO: V.5 DATE: MAR/14/2005 PAGE: 1 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201000539
Page 2
Selection Guide
Viewing
Part No. Dice Lens Type
Iv (mcd)
@ 50mA
Min. Typ.
Angle
2θθθθ1/2
AA5060SYC/E SUPER BRIGHT YELLOW (InGaAIP) WATER CLEAR 280 500
Note:
θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.
1.
Electrical / Optical Characteristics at TA=25°C
Symbol Parameter Device Typ. Max. Test ConditionsUnits
λpeak
λD
∆λ1/2
C Capacitance Super Bright Yellow 33 pF VF=0V;f=1MHz
VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA
IR Reverse Current Super Bright Yellow 10 uA VR = 5V
Peak Wavelength Super Bright Yellow 592 nm IF=20mA
Dominant Wavelength Super Bright Yellow 590 nm IF=20mA
Spectral Line Half-width Super Bright Yellow 20 nm IF=20mA
100°
Absolute Maximum Ratings at T
A=25°C
Parameter Super Bright Yellow Units
Power dissipation 125 mW
DC Forward Current 50 mA
Peak Forward Current [1] 200 mA
Reverse Voltage 5 V
Operating/Storage Temperature -40°C To +85°C
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
SPEC NO: DSAD0900 REV NO: V.5 DATE: MAR/14/2005 PAGE: 2 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201000539
Page 3
Super Bright Yellow AA5060SYC/E
SPEC NO: DSAD0900 REV NO: V.5 DATE: MAR/14/2005 PAGE: 3 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201000539
Page 4
AA5060SYC/E
Recommended Soldering Pattern
(Units : mm)
Tape Specifications
(Units : mm)
If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength),
the typical accuracy of the sorting process is as follows:
1. Wavelength: +/-1nm
2. Luminous Intensity: +/-15%
3. Forward Voltage: +/-0.1V
Note: Accuracy may depend on the sorting parameters.
SPEC NO: DSAD0900 REV NO: V.5 DATE: MAR/14/2005 PAGE: 4 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201000539
Loading...