BLUETOOTH SPEAKER
KTS-1061
OFF
ON
SPA657
previous
1. DC 5V: Plug the Micro USB cable to the speaker and
connect other end USB port to the power source.
(DC 5V)
2. Aux: Audio input jack when connect. Enable the sound
source connection active devices (PC, digital media
player, mobile phones and other audio-visual products).
3. USB slot: Used to read the Mp3 files in FAT32 format
with maximum size of 32GB
4. TF slot: Used to read the Mp3 files in FAT32 format
with maximum size of 32GB
5. Play/Pause: Under USB/TF/Bluetooth mode, short
press for play and pause;
6. M: To change mode during USB/TF, Bluetooth, FM
and Aux-in mode. Press and hold to switch on and
off the light
7. PREV: USB/TF/Bluetooth/FM mode: short press to
move previous FM channel / track. long press to
decrease the volume.
8. NEXT: USB/TF/Bluetooth/FM mode: short press to
move next FM channel / track.long press to increase
the volume.
9. MIC-IN: Connect with the MIC when you need.
be
6.5
Note: It's not available in FM mode.
10W
FCC Statement:
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Loading...