SPEAKER USER MANUAL
MODEL NO.: KTS-1042
Accessories
Wireless speaker: 1PCS
Operation manual: 1PCS
Power supply cable: 1PCS
3.5MM Audio cable: 1PCS
Remote control: 1PCS
Wired microphone: 1PCS
Adapter: 1PCS
Specifications
Operation range: 10M
Battery: built-in rechargeable 2*1200mAh Lithium-ion
Output power: 15W*2
Input voltage: DC 5V
Frequency response: 100Hz-20KHz
Loudspeaker: 6.5inch 15W*2
Distortion: ≤10%
S/N ratio: ≥80dB
Multimedia input: Micro SD/USB
FM frequency range: 87.5-108.0Mhz
Description of parts
1. LED display
2. Microphone jack
3. Power ON/OFF
4. Charging port
5. Previous track
6. Play/Pause
7. Next track
8. M button
9. AUX-IN jack
10. USB slot
11. Micro SD(TF) card slot
12. Vol--/ Vol+
Wireless
Turn on the speaker and it will come into the wireless mode directly. After pairing
the device, it can play the music. Short press“ll”
or "
turn up the Volume.
" button to previous track or next track. Revolve the knob to turn down and
button to Play/Pause, press " "
AUX-IN
AUX-IN, Insert the audio cable into AUX slot, and press M button to switch to Aux-in
mode. Long press "
Under AUX-IN status, it cannot shift previous track or next track by the speaker unit,
only can control it by the device itself.
"or" "buttontoincreaseordecreasetheVolume.
USB/TF Card
Insert the U flash memory or Micro-TF card into the USB/TF slot, KTS-1042 will
read the MP3 format music automatically. Press ll
"or" " button to previous track and next track. Revolve the knob to turn down
and turn up the Volume.
button
to Play/Pause, press "
FM RADIO
Press M button to search FM channel automatically. This operation will scan all FM
stations and Pre-record them to memory. The scan procedure will take several
minutes and cannot be interrupted. Once completed, you can short press "
" button to move forward or backward. Long press " "or "buttonto
increase or decrease Volume.
"or
KARAOKE
Insert the wireless microphone cable into the MIC port
Charging
PlugtheUSBcableintospeakerchargingportandconnecttopowersource.
Red LED on panel when charging.
HOWTOUSETHEREMOTECONTROL
1. Unit on/off
2. MODE: Mode shift button. Short press and shift to USB/TF mode once, more
to AUX/FM mode & default mode will be Wireless mode. Press and hold the
Mode button on the host speaker to reactivate the paring process between
speakers.
3. Mute
4. : Under FM/USB/TF/ Wireless mode, short press to move to previous
channel/track.
5. Play/Pause
6.
7. Decrease the volume
8. Increase the volume
9. EQ: Press to exchange the EQ mode.
10. LED: Turn on or turn off the LED light.
Under FM/USB/TF/Bluetooth mode, short press to move to next
channel/track.
Federal Communications Commission (FCC) Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energ y and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the us er is encouraged to try to correct the interference by one or more of
the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
●Consult the dealer o r an experienced radio/TV technician for help.
Warning: Changes or modifications made to this device not expressly approved by Shenzhen
KingBoard Technology Co., Ltd. may void the FCC authorization to operate this device.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the us er’s
authority to operate the equipment.
Loading...