Shenzhen KingBoard Technology Co., Ltd.
BLUETOOTH TRANSMITER
KBZ-818
Remark
1. keep out of reach of children!
2. Please use the original accessories
3. If unit have problem , please contact with the seller.
Disassemble the unit by User is not allow
4.Keep good ventilated environment when charge the unit, do not keep near inflammables , oxidizers
and explosive
Operation guide
A:“ “
Short press：
Ⅰ、 USB or SD mode: Last track
Ⅱ、 Charge mode：No function
Ⅲ、Bluetooth mode：change to last station
Long press：
Ⅰ、USB or SD mode：Decrease the volume
Ⅱ、Charge mode: Decrease the volume
Ⅲ、Bluetooth mode：Decrease the volume
B“ “
Short press：
Ⅰ、 USB or SD mode: Next track
Ⅱ、Charge Mode：No function
Ⅲ、Bluetooth mode：change to next station
Long press：
Ⅰ、USB or SD mode：Increase the volume
Ⅱ、Charge mode: Increase the volume
Ⅲ、Bluetooth mode：Increase the volume
C. “ / “
Short press
Ⅰ、USB or SD mode: Play or Pause。
Ⅱ、Aux in mode：Mute
Ⅲ、Bluetooth mode：Play or Pause/ Answer or hand up the phone/Hang up
Long press
Ⅰ、USB or SD mode: Change the mode
Ⅱ、Aux in mode：Change the mode
Ⅲ、Bluetooth mode: Change the mode
Function:
Connect to the Bluetooth device
Important noted: BLUETOOTH TRANSMITTER frequency must meet the radio
frequency
1 .Put it into to Car Cigar hold, BLUETOOTH TRANSMITTER will on automatically,
and will have the indicate sounds .Turn ON the Bluetooth function on your mobile
or other device and search for the speaker, model name.
2. Pair the device., it can connect automatically
3. Once device is paired Bluetooth will automatically connect when unit is turned on
subsequently.
Operation
guide
Remote control
1. How to play
and stop
Play button
2.How to
adjust the
Volume
Press “VOL.+” button: Increase the Volume
Press “VOL.-” button: Reduce the Volume
3. How to
change the
frequency
Press “CH+ ” button: Increase 0.1MHZ
Press “CH-” button: Reduce 0.1MHZ
4. How to
choose music
Press the “ ” Button: Play the next song
Press the “ ” Button: Play the previous song
5. How to set
EQ
Press “EQ” button to switch your favorite EQ
USB/SD Card
`Insert the U flash memory or SD card into the USB or SD slot., it will read the MP3
format music automatically. Press the “ / ” to Play/Pause, short time press
the" " and the" "to Prev. and Next, Long time press the" "and
" " button to decrease and increase the Volume.
.
Remote control Operation guide:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
Loading...