KING VQ4500, VQ4510 Owner's Manual

VQ4500 & VQ4510 Owner’s Manual

This manual contains detailed information on your KING Tailgater.

To start watching TV right away,

use the Quick Reference Guide.

For

PRODUCT REGISTRATION

To provide ongoing technical support and to better

facilitate warranty processing, please register your product

at www.kingconnect.com/products/product-registration/.

TABLE OF CONTENTS

Introduction ..........................................................2

Important Safety Instructions ............................................2

KING Tailgater Package Contents ........................................2

Apply Rubber Feet to Antenna Unit .......................................3

About Signal Loss .....................................................3

About Satellite TV Reception ............................................4

Connect Receiver to TV ................................................4

KING Tailgater Setup ..................................................5

KING Tailgater Operation ............................................ 6-12

First Time KING Tailgater Operation with New Receiver ...........6-9

Standard KING Tailgater Operation.........................10-12

Second Receiver Operation ......................................... 14-15

Proper Care of Your Equipment .........................................16

Security ............................................................16

Accessories.........................................................17

Permanent Installation ............................................. 18-21

Troubleshooting ..................................................22-25

Manufacturer’s Limited Warranty ........................................26

FCC Guidelines......................................................27

DISH and Tailgater are registered trademarks of DISH Network L.L.C.

KING and Dome Magic are registered trademarks of Electronic Controlled Systems, Inc.

HDMI is a registered trademark of HDMI Licensing L.L.C.

Page 1

INTRODUCTION

Thank you for choosing DISH and the KING Tailgater Portable HDTV System!

You are about to experience the excitement of DISH satellite television programming and the
convenience of the KING Tailgater portable antenna, which delivers the very best picture and sound
quality wherever you go.

The KING Tailgater allows you to decide how and where you watch your DISH service. If you need to
activate service, call 1-800-963-DISH (3474) to speak with a mobile antenna expert.

IMPORTANT SAFETY INSTRUCTIONS

1. Please read this Owner’s Manual thoroughly before using the KING Tailgater.

2. Keep this Owner’s Manual and the included Quick Reference Guide in a safe place for future
reference.

3. Follow all instructions and warnings. Set up and operate the KING Tailgater in accordance with
the instructions.

4. Do not power wash the KING Tailgater. Do not submerge the KING Tailgater or place in
standing water. Hand wash only with mild soap and water. See page 16 for additional care
instructions.

5. Do not operate near any indoor or outdoor heat source such as radiators, heat registers,

stoves, barbecues, campres, or other items that produce heat.

6. Servicing may be required if the unit has been dropped or damaged in any way or if the unit
does not operate normally. Call the KING Service Department at [phone].

7. Tighten all of the coax cable connections only by hand. If you use a wrench, you may
over tighten the connections and damage your equipment.

8. To avoid risk of electric shock, unplug your receiver before connecting the KING Tailgater in
damp or wet conditions.

KING TAILGATER PACKAGE CONTENTS

Page 2

NOTE: The VQ4510 includes the receiver and cables.

APPLY RUBBER FEET TO ANTENNA UNIT

IMPORTANT!

Do not apply rubber feet if roof mounting the antenna unit.

ABOUT SIGNAL LOSS

Because of the small size of the highly portable KING Tailgater, signal strength may not be as

strong as with a xed home antenna.

OBSTRUCTIONS

The KING Tailgater requires an unobstructed view of the southern sky for the best signal reception.

Be sure to place the KING Tailgater in a location free from obstructions such as people, trees,
buildings, vehicles, etc. This will allow for the strongest signal and will help prevent any interruption to
your programming. Point the handle approximately north to speed up search time.

DO NOT BLOCK THE KING TAILGATER’S LINE OF SIGHT
TO THE SATELLITES IN THE SOUTHERN SKY AT ANY TIME!

IMPORTANT!

If you move the antenna unit any

time during or after a scan, you will

have to repeat the scan process.

RAIN AND SNOW FADE

Though rare, heavy rain, snow, or dense cloud cover can reduce the satellite signal, which may
interrupt your programming. Your programming should return as conditions improve.

Page 3

ABOUT SATELLITE TV RECEPTION

Satellite television uses satellites in a geostationary orbit over the earth. This type of orbit enables
the satellites to stay aligned over one place on the surface of the earth and to transmit your television
programming to the KING Tailgater when pointed at the appropriate satellite.

Your television programming is delivered from up to 3 satellites located at the 110°, 119°, and 129°

west longitudes. The KING Tailgater will automatically nd and then switch between satellites as you

change channels to offer you the ideal viewing experience.

Due to the low look angle for the 129 satellite in the northeastern region of the United States, you may

experience difculty viewing programming from the 129 satellite while in this area. (Programming

from the 110 and 119 satellites should still be available.)

CONNECT RECEIVER TO TV

DO NOT PLUG IN OR TURN ON RECEIVER AT THIS TIME.

1. Connect your DISH HD Solo Receiver (ViP211z, ViP211k, ViP211 or 411)1 to your TV using the
best connection type supported by your TV. (See your TV owner’s manual for its connection
options. Connection type and location may vary by model.)

Back of DISH ViP211z Receiver

2

HDMI® Cable

(High Denition Connection)

OR

Composite Cables

(Standard Denition Connection)

1) Receiver models compatible with the KING Tailgater may change. This list may not be complete.
Please visit www.kingconnect.com/dish-receivers for the most up to date receiver information.

2) Your receiver may also have standard denition “TV SET OUT” and “S-VIDEO” ports, and high denition
“COMPONENT” ports to view video. See your receiver owner’s manual for more information.

Page 4

KING TAILGATER SETUP

The KING Tailgater requires an unobstructed view of the southern sky for signal reception. Be sure
to place the KING Tailgater in a location free from obstructions such as trees, buildings, etc. (See
page 3.) Point the handle approximately north to speed up search time.

HAND TIGHTEN COAX. OVER TIGHTENING CAN DAMAGE CONNECTIONS.

1. Connect one end of the supplied RG-6 coax cable to the MAIN port on the KING Tailgater and
place in position. It is recommended you use only the supplied RG-6 coax cable.

2. Connect the other end of the supplied coax cable to the SATELLITE IN port on your receiver.

• Do not put the KING Tailgater where it can be bumped, knocked over or struck by a person or vehicle.

• Do not put the KING Tailgater near any heat sources.

• Do not route the coax cable where it can be tripped on or run over by a vehicle.

• Do not over tighten the coax cable connections.

• Do not put sharp bends or kinks in the coax cable.

NOTE: Place the KING Quest on a stable and reasonably level surface with a clear view of the southern sky.

When placing the KING Quest in position, be sure surface is dry and free of loose dirt or sand.

3. Plug your receiver into a 110 volt AC power source.

The green power light on your receiver should illuminate or begin cycling on and off.

Wait for the green light to turn solid.
This may take up to two minutes.

If it does not turn solid, power on your receiver using
the front panel POWER button. (On “z” models,
this is located behind the door panel.)

4. Plug in and turn on your TV.

Front of ViP®211z receiver with door open

In your TV’s input selection menu, choose the input that matches the connection from your
receiver. (Example: If using an HDMI cable from your receiver, choose the HDMI input on your
TV.) See your TV owner’s manual for details.

Page 5

KING TAILGATER OPERATION

IF YOU ARE USING A NEW RECEIVER WITH THE KING TAILGATER, YOU MUST
FOLLOW THE FIRST TIME SETUP PROCEDURE STARTING BELOW.

AFTER THIS FIRST TIME PROCEDURE, YOU CAN USE “STANDARD KING
TAILGATER OPERATION” STARTING ON PAGE 10.

FIRST TIME KING TAILGATER OPERATION WITH NEW RECEIVER

MAKE SURE TO INSTALL THE BATTERIES IN THE RECEIVER’S REMOTE
CONTROL (INCLUDED WITH REMOTE CONTROL).

1. Point your receiver’s remote at the front of
the receiver and press SAT.

Press RECORD.

When a number appears in the box,
verify CONTINUE is highlighted.

Press SELECT on your remote.

The Portable Antenna Setup screen

will display.

Page 6

IN STEPS 2-6, DO NOT BLOCK THE KING
TAILGATER’S LINE OF SIGHT TO THE SATELLITES
IN THE SOUTHERN SKY AT ANY TIME!

2. Use the arrow buttons on your remote to
highlight the letter group that includes the
rst letter of the state you are currently in.

Press SELECT.

IMPORTANT!

If you move the antenna unit any

time during or after the scan,

you will have to repeat steps 2-6.

3. Highlight the state you are currently in
from the state menu.

Press SELECT.

4. Verify Scan is highlighted.

Press SELECT.

The scan will begin and may take up to
several minutes to complete.

Page 7

The receiver will download software

for the KING Tailgater. This step may take
20-25 minutes.

5. The receiver will reset and the Mobile
Antenna Setup Screen will appear.
Repeat steps 2-4 to start
a second scan.

The unit will scan a second time.

Page 8