Model No: P 070
Saç Kesme Makinası / Hair Cutting Machine
Kullanma Kılavuzu / Instruction Manual
P 070
AquaDuo
Saç Kesme Makinası
Hair Cutting Machine
MAIN PARTS
1. Cutting head
2. Hair trimmer
3. Detachable blade
4. Cutting length control wheel
5. On/Off switch
6. İndicator light charge control
7. Charging stand
1
2
3
4
7
6
5
1
IMPORTANT SAFETY INSTRUCTIONS
RECHARGEABLE HAİR TRİMMER:
■This hair is designed to shorten and trim hair and beards.Do not use the hair trimmer
to cut artificial hair.
HAZARD TO CHILDREN:
■Keep children away from this product because they often under estimate to ricks
involved in handling electrical equipment.There is considereble danger of cutting
yourself with the sharp shaving head.
■Small parts cen be higly dangereus if swallowed.Therefore, keep the hair trimmer and
accessories out of the reach of infants.
ELECTRICAL HAZARDS.
■Clean the shaving head by rinsing it off under water tap.However the hair trimmer itself
must not be immersed in water.The power card and mains adaptor must not come into
contact with water or other liquids, there is a risk of elektric shock.Therefore, never use
the hair trimmer over a filled sin kor while having a bath.If the trimmer or charging
station sholuld fall into the water, immediately pull the mains adaptor out the socket.
■Unplug the trimmer if you do not plan to use it four a longer period of time, if the
trimmer malfunctions during use, during thunderstorms and when cleaning.
■Do not use if the trimmer, power cord or mains adaptor show any signs of damage.
■Do not attempt open the appliance.Only have repairs made to the trimmer the power
cord or mains adaptor by an authorized dealer. Improper repairs may expose the user to
considerable hazards.
■Only use the mains adaptor supplied with the trimmer or an adaptor with the same
technical features otherwise the appliance could be damaged.
■Only plug the mains adaptor into a properly installed 20-240V – 50Hz. Socket
Other causes of injury
■The appliance inchudes a double rechargeable battery pack.It must not be dis mantled
ex posed to an open flame or short circuried.
■Do not operate the appliance if the attachment is damaged.The shaving head is very
sharp be very careful when you use the appliance without the attachment.
RISK OF INJURY CAUTION-DAMAGE TO THE HAIR TRIMMER
■Only use original accessories. Never atiempt to sharpen the cuting head yourself
Only cut natural hair with the trimmer.
Never expose the trimmer to temperatures below 10 C or higher than + 40C for longer
periods of time.
LOADING THE RECHARGEABLE BATTERY
■Before first time use, the trimmer must be fully charged
1.Slide the On/ Off switch downwards.
2.Insert the plug of tme mains adaptor into the power jack of the hair trimmer.
3.Plug the mains adaptor into a power socket outlet.
■The indicator light with not go out when the rechargeable battery is loaded
■Note about the rechargeable battery:
■The rechargeable battery does not have its full capacity from the start.To abtain the
maximum charge capacit, the battery should be used until the batteries are completely
flat.The batteries ahould then fully recharged.To increause the life of the rechargeable
batteries this charging and discharging procedure ahould be repeted approximately
twice a year.
■Using the trimmer without charging the batteries before hand
Mains eledtricity ( via the mains adaptor) can also be used to power the trimmer
1.Connect the hair trimmer as described in the section.Loading the recharge able
battery
2.Umplug the adaptor after use.
■Tips and hints concerning use
■This function evens out unevenlydistributed hair volume.
GUIDE COMB
■Use the guide comb to shorten hair evenly to a length of 3 – 15mm.To set the desired
lenght press the closure latch of the guide comb and slideit either upwards or down
wards.
■The set length is indicated on the scale of the appliance.
■Shapiang the beard and shaving the back of the neck is done without attacments
1.Remove the attachment
2.Draw the cutting head at a low angle along skin without applying pressure.
CLEANING AND CARE
1.Remove the comb attachment
2.Press the shaving head towards the back and remove it.
3.Brush out shaving head insert.
4.Reinsert the shaving head by inserting the latch of the shaving head into the groove of
the casing.
5.Press the shaving head back into the casing until it engages audibly.
6.Wet/ dry design for use in shower and easy cleaning
Oiling the shaving head.
Oil the shaving head from time to time if you use the trimmer reguarly. Use non-corroding oil, for example sewing machien oil.
Loading...