Kinesis FS32AJ-JSB User Manual

Kinesis® JSB™

USB foot switch family

(joystick button emulation)

USER’S MANUAL

USER’S MANUAL

Kinesis® JSB™ USB foot switch family

(joystick button emulation)

For any USB system capable of providing generic HID joystick drivers for USB joysticks

Models covered:

FSMJ2-JSB: control module only, with two input jacks
FSMJ4-JSB: control module only, with four input jacks
FS12J-JSB: control module with two input jacks, one pedal
FS22A-JSB: dual angled pedals mounted on steel base
FS22AJ-JSB: dual angled pedals mounted on steel base with one jack for optional input device
FS32A-JSB: triple angled & adjustable pedals, mounted on steel base
FS32AJ-JSB: triple angled & adjustable pedals, mounted on steel base. Jack for optional input

Optional input accessories

FS007mp: single foot pedal with mini-phono plug
FS002HT8: Hand trigger, 8 foot cable with mini-phono plug.

*Waterproof (IPX8) models are available by special order.

September 2014 Edition

© 2010-2014 by Kinesis Corporation. All rights reserved. Printed in the U.S.A. on recycled paper. Please recycle! The Kinesis

KINESIS is a registered trademark of Kinesis Corporation. JSB is a trademark of Kinesis

website is located at www.kinesis.com
Corporation. Information in this document is subject to change without notice. No part of this docum
transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of
Kinesis Corporation.

Cover: Triple pedal model shown (FS32A-JSB)

.

ent may be reproduced or

REGULATORY APPROVALS

FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential installation.This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected
 Consult the dealer or an experienced radio/TV technician for help

Warning

To assure continued FCC compliance, the user must use only shielded interfacing cables when connecting to
computer or peripheral. Also, any unauthorized changes or modifications to this equipment would void the user’s
authority to operate.

INDUSTRY CANADA COMPLIANCE STATEMENT

This Class B digital apparatus meets all requirements of the Canadian Interface-causing Equipment Regulations. Cet
Appareil numerique de la classe B respecte toutes les exiginces du Reglement sur le material broilleur du Canada.

CE COMPLIANCE FOR EMISSIONS AND IMMUNITY

This device has been tested to comply with the following European standards for emissions and immunity for ITE and
medical equipment: En 55022, En 55024, EN 61000-3-2/3, and EN 60601-1-2.

MEDICAL PRODUCT SAFETY

CONFORMS TO UL STD 60601-1; CERTIFIED TO CSA STD C22.2 NO. 601.1

4007055

The ETL Recognized Component mark on the product label indicates compliance with UL 60601-1 and CSA Std
C22.2 No. 601.1 standards for medical use. These products must be used with a UL listed computer to comply with
UL safety standards. The label will also indicate IPX1 per UL and CE standards for “drip-proof” water resistance.
Custom, non-programmable waterproof (IPX8) models are also available by special order. This product should not be
used in the presence of a flammable atmosphere such as an anesthetic mixture with air, oxygen, or nitrous oxide.

4