kincrome Evolution K7925, Evolution K7927, Evolution K7945, Evolution K7963 Operation Manual
Non-Locking
Castors (2)
Locking
Castors (2)
4 x Hex 5mm
Bolts for
Trolley Handle
13mm x 16 Bolts
(16) for Castors
(with Washers)
Trolley Handle x 1
2 People
13mm Spanner
For Castors:
5mm Hex Key
For Handle:
Tool Trolley
6 x Liners
Keys x 2
K7925
5 Drawer
675mm (26”)
Operation Manual
Parts List
IMPORTANT:
This operating manual contains important safety information,
read carefully & understand all information before operating
the trolley. Save this manual for future use.
Tools & Assistance
Required for Trolley:
Included
1
Measurements: Weight: 42kg
(External - With Castors - 125 x 50mm (5 x 2”) x2 Locking)
WIDTH 675 mm DEPTH 466 mm HEIGHT 801 mm
Measurements - Top Section
WIDTH 665 mm DEPTH 466 mm HEIGHT 15 mm
Shallow Drawers
WIDTH 566 mm DEPTH 405 mm HEIGHT 62 mm
Deep Drawers
WIDTH 566 mm DEPTH 405 mm HEIGHT 143 mm
40kg+
This product requires a two person lift
- use proper lifting techniques
2
Tool Trolley
Assembly Instructions
Maintenance
Removing the Drawers
• Fully extend the empty drawer.
• Push up the right grey release lever while
pushing down the left grey release lever.
• Pull the drawer outward until it is
released from the drawer slide.
Re-Inserting The Drawers
• Extend the drawer slides.
• Insert the brackets on each side of the
drawer into the slots on the slides, being
careful that they are properly positioned.
• Once properly inserted, completely close
the drawer to set the slides in their
proper positions.
• Periodically tighten all hardware
• Periodically lubricate castors
• Lubricate the slides twice a year
• Lubricate the lock with graphite annually
• Use a damp Microfibre cloth to clean
all surfaces
Push up the
right grey release lever
Pull down the
left grey release lever
Handle Installing
• Position the trolley side handle behind the
holes on the trolley.
• Attach with (4) bolts, and tighten with
a 5mm Hex Key.
Castor Installing (If applicable)
• Be sure the drawers are locked and lay
the trolley on its side.
• Secure castors to the unit using the
13mm bolts provided.
• Tighten with a 13mm Spanner.
• Repeat this process for the castors on
the opposite of the trolley.
• Return the trolley to its upright position.
Caution: Do not over tighten the bolts.
Caution: Both locking castors must be
fitted to front of trolley.
1
2
1
2
1a 1b
2
1
K7925
5 Drawer
675mm (26”)
Loading...