Kinco F7, F10 Installation Instructions And Instructions For Use

1.1 Environmental Requirement

Please make sure that AC power,PLC output modules,starters,relays and other types of

electrical interface device are far away from the back of this product.

1.2 Power Requirement

 Input voltage: 18~28VDC;

 Particularly note that there must be enough distance between this product and

converters or switch mode power supply. Make sure that the input and output cables

of that kind equipment are shield cable and the shielding network is connected with the

ground.

 Make sure that the DC power and AC power is isolated.

 Do not use common power with perceptual load or input circuit of the controller.

 An Internal fuse will prevent damage for over voltage condition, however it

isn’t guaranteed the internal electronic components are not damaged.

 Chassis ground must be used.

2.1 Installation Instructions

It uses bracket installation which is compatible with VESA standard.The

4 installation holes for F7 is 75mm*75mm,and for F10 is 100mm*100mm,the

installation holes distance is as shown in chapter 2.2.

2.2 Dimensional Drawing (mm)

F7/F10

Human Machine Interface

Installation Instruction

Kinco Electric (Shenzhen) Ltd.

Tel：[phone]

Fax：[phone]

Web: www.kinco.cn Email：[e-mail]

Kinco WeChat

Add: Building 1, No. 6 Langshan 1st Rd, Hi-tech Park

North, Nanshan,Shenzhen,China.

http：//www.kinco.cn Email：[e-mail]

1.Installation Note

2.

Installation Description

2.3 Power Connection

Before connecting the power, please make sure all local and national electrical

standards are met. For power cables, please select cables with these specifications:

overall diameter 6.--8.3mm, 7 cable cores,the internal cable cores should be 22AWG or

above.The power cable is welded to WF-16 connector.The definition of the WF-16

connector is as shown in chapter 3.1.In the picture,24V_PWER is connected to

DC24V,and 24V_GND is connected to 0V.

3.1 Power Supply&Serial Port

The power supply and serial port use the same connector,as shown in

following picture.

Note:There are two communication ports.One is COM0,it supports RS485.The

other one is COM2 which is used for RS232 communication and downloading

project.

3.2 USB HOST

This interface is mainly used for importing initial LOGO,user ’s configuration uploading/

downloading,recipe data import/export and historical data export.

4.1 Instructions for entering Operation Mode selection window

Press and hold the touch panel before power on HMI,then power on

HMI.Release your help after HMI enter operation mode selection window,then

select the operation mode.If no any operation in 20s after entering

operation mode selection window,HMI will enter application mode

automatically.

3.External Interface

4.Operation Mode

F7

F10

4.2 Descriptions of functions in Operation Mode selection window

After entering operation mode selection window,it will popup a

menu.Follows are the descriptions of the functions in the menu:

System Setup：Press this button to enter system setup window.This

window is used to set initial window,screen saver time,buzzer and

brightness adjustment.After setting,press Restart button to restart HMI.

Firmware Update：Press this button to enter firmware update window.This

window is used to update firmware.Normally this mode is not advised to

use without guiding by manufacturer.

Touch Calibration：Press this button to enter touch calibration window.It

will restart HMI automatically after calibration successful.There is a

timer in this button,it will enter application window if there is no

operation within 20s.

Stop timer: Press this button to stop the 20s timer.

Note:There is a multi-languages button,it is used to switch the English

and Chinese.