Kimo MP 100, MP 105, MP 101, MP 112, MP 120 User Manual

Manometers

MP 100 - 101 – 105– 112

MP 120

''OK'' key

1x ''To validate''
or ''Self-calibration'' see P2.

''Function'' key

''Select'' key

1x : ''Hold'' : measure holding
2x : ''Min/Max'' : display of minimum and

maximum values from channel 1
since last request.

3x : ''Min/Max'' : display of minimum and
maximum values from channel 2
since last request.

4x : Back to held measure.

See table
''Functions available from main screen''

ON : Switch-on
OFF : Switch-off
Escape : Return to previous screen

''On / off'' key

1x Level 1

2x Level 2

3x No backlight

''Backlight'' key

Rugghölzli 2
CH - 5453 Busslingen

Tel. [phone]
Fax [phone]

[e-mail]

www.sentronic.com

Produkte, Support und Service

SEN

TRONIC

AG

NTang – MP100 – 120 - 12/08 B – We reserve the rigth to modify the characteristics of our products without notice.

Once returned to KIMO, required waste collection will be assured in the respect of the environment in accordance to 2002/96/CE guidelines relating to WEEE.

Functions available from main screen

How to change battery

1. Remove the front part at the back of the
instrument.

2. Remove old battery.

3. Insert the new battery in accordance with proper
polarity drew inside the housing.

4. Replace the front.

Velocity
activation

1x

Select air
velocity unit

Press to activate or deactivate Validate with

Press to scroll down units Validate with

Ambient
Temp.

6x

Enter value with Validate with

Atmospheric
Pressure

7x

Enter value with Validate with

Select
pressure unit

Press to scroll down units Validate with

Automatic
shut-off

Press to scroll down units Validate with

Beep

Press to activate or deactivate Validate with

2x

3x

4x

5x

Select pressure
units

Press to scroll down units Validate with

1x

Automatic
shut-off

Press to scroll down minutes Validate with

2x

Beep

Press to activate or deactivate Validate with

3x

Self-calibration

1x

Start of self-calibration countdown*

Functions available from main screen (only for MP120 instrument)

Self-calibration

1x

Start self-calibration countdown*

*self-calibration is performed by disconnecting the two pressure inlets of the sensor, then by pressing AutoZ key.

Using Pitot tube

1. Connect the Pitot tube to MP120 instrument.

2. The probe must be placed at the center of the duct and
parallel to the air flow.

3. Press then to activate velocity.

Dynamic pressure = PT - PS

+

-

(+) Static
Pressure PS

(-) Total
Pressure PT

Rugghölzli 2
CH - 5453 Busslingen

Tel. [phone]
Fax [phone]

[e-mail]

www.sentronic.com

Produkte, Support und Service

SEN

TRONIC

AG