Kimberley MONACO-MKII KRB60EP Installation Instructions Manual
1
Measure and mark the location where the inner
runners will be installed.
INSTALLATION INSTRUCTIONS
MODEL: MONACO-MKII KRB60EP
Ph: +(61) 3 9768 5777
Fax: +(61) 3 9768 5788
Email: sales@kimprod.com.au
kimprod.com.au
Manufactured by:
Kimberley Products Pty. Ltd.
5 Abbotts Rd, Dandenong Sth
Victoria 3175, Australia
2
Once mounting positions have been accurately
marked, use two self tapping screws to secure in
each runner.
BEFORE YOU START
Model KRB60EP suits installation to cabinets with
450mm standard carcass. (418mm Internal).
224
185
37
395
Preassemble runner cover to
hamper frame. Gently tighten
as you may need to make
further minor adjustments
before completion.
3
Lid support bracket
(See assembled example in Step 3)
Lid support bracket
- Screws (8g x 5/8 csk) x 12
- Screws (M5 x 12mm) x 8
TOOLS REQUIRED
- Philips head screwdriver
- Drill & 2mm Drill bit
ASSEMBLY KIT
D/N: SKRB60EP-160817
4
Pull each side of the inner runner out as
shown. Place assembly frame runner cover
over runners.
Once both are in place gently push bin frame
back until you hear it click in place.
Move bin frame in and out to ensure the
runners have a smooth movement. If the
movement isn’t as desired then adjust before
proceeding to the next step.
5
Once you are satisfied with the runner
movement, tighten all screws as shown.
Note: At this point fit the lid between the
support brackets (Shown step 3).
Loading...