Kikusui PL02-TOS Operation Manual
The PL02-TOS warning light unit indicates that a Kikusui withstanding
OPERATION MANUAL
Warning Light Unit
PL02-TOS
Part No. Z1-002-690, IA002883
Dec 2018
Illuminates or blinks in red when power is input.
BLINK ON/OFF
light. Turn the switch ON to set the warning light to blink.
AC/DC24V
Connector for the input power. There is no polarity.
A
B
Shank diameter: ø3; tip width: 2.6 mm
10 mm
voltage tester, withstanding voltage and insulation resistance tester, or
electrical safety analyzer (hereafter referred to as the Tester) that has a
STATUS OUT (24 V) terminal is in a test state.
WARNING
For your safety, be sure to check the warning light illumi-
nates before using it. Do not leave or use the PL02-TOS
with the cover removed or when the cover is broken.
Names of Parts
Cover
Switch used to select illuminating or blinking of the warning
■ Connecting to the connector
1 Remove 10 mm of coating from
the tip of the wires.
2 Insert a flat-blade screwdriver
into A, and open B.
3 Insert the wire into B. Take care
to prevent the coating from becoming caught in B.
4 Gently pull on the wire to confirm that it is securely connected.
Applicable wires
• Wire length
•Solid wire
• Stranded wire
Less than 3 m
ø0.4 to ø1.2 (AWG26 to 16)
2
0.3 mm
Element wire diameter ø0.18 or more
to 1.25 mm2 (AWG22 to 16)
Operating Procedure
WARNING
Tester
rear panel
Less than 3 m
PL02-TOS
STATUS OUT
AC/DC24V
+
COM
Be sure to turn off the Tester before connecting the
wires.
1 Connect the AC/DC24V connector of the PL02-TOS and the STA-
TUS OUT terminal of the Tester.
2 Set the Tester so that a signal is output from the STATUS OUT termi-
nal when a test is in progress.
3 The PL02-TOS is activated when a test is started on the Tester.
■ Connection example
CAUTION
• A rubber magnet is attached to the bottom of the
PL02-TOS to fix it in place. However, do not place the
PL02-TOS on a slanted surface, uneven surface, or a
place with vibrations. The rubber magnet cannot with-
stand strong shock. Be careful not to drop the PL02-
TOS by carrying out acts such as yanking on the con-
nection cord. Such acts can damage the warning light.
• If the cover needs cleaning, gently wipe using a soft
cloth with water-diluted neutral detergent. Do not use
volatile solvents such as thinner or benzine.
2 PL02-TOS
Loading...