KIDZTECH TOYS 89023 49MRX, 89023 27MTX, 89023 49MTX User Manual

RADIO CONTROL

Cautions

1. Do not attempt to disassemble the Vehicle or Transmitter

2. Do not operate the Vehicle with same frequency with other player(s) in same location that will interfere and make the Vehicle out of control.

3. Make sure the batteries are installed with correct polarities (+/-) as shown inside the battery compartment

Contents

RC Vehicle (Vehicle) x 1
RC Transmitter (Transmitter) x 1
Antenna for RC Transmitter x 1
Instruction Manual x 1

Battery Precaution

1. Alkaline batteries are recommended to be used

2. Only batteries of the same or equivalent type as recommended are to be used

3. Do not mix alkaline, standard or rechargeable batteries

VEHICLE
BIG FOOT

Battery Requirement

1. Vehicle: 4 x 1.5V ”AA” batteries

2. Transmitter: 1 x 9V battery

4 x AA

For Vehicle

( Not Included )

1:26

1 x 9V

For Transmitter
( Not Included )

4. Remove the package and take out all accessories before giving the Vehicle and Transmitter to child to play

FCC label compliance statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

4. Do not mix old and new batteries or different type of batteries

5. Non-rechargeable batteries are not to be charged

6. If rechargeable batteries are to be used, they are only to be charged under adult supervision

7. Rechargeable batteries are to be removed from the product before they are charged

8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions

9. Remove all batteries from the Vehicle and Transmitter when not in use

10. Exhausted batteries are to be removed from the product

11. The supply terminals are not to be short-circuited

12. Dispose of batteries properly. Do not dispose the batteries in fire – it may cause them to explode or leak causing injury or damage

13. Battery installation and removal must only be done by adult

Battery and Antenna Installation

For Vehicle (Fig. 1 and Fig. 2)

1. Switch OFF the power

2. Unscrew the screw on the battery cover

3. Open the battery cover

For Transmitter (Fig. 3 and Fig. 4)

1. Switch OFF the power

2. Unscrew the screw on the battery cover

3. Open the battery cover

RSS-310 Compliance Statement:

This device complies with Industry Canada Licence-exempt RSS-310. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Declaration of Conformity

The product is in conformity with the requirement of EU Directive 1999/5/EC

Environmental notes:

The whole product also does not belong to household waste at the end of the product life.
You can return it at collection points for the recycling of electronic and electronical instruments
The symbol on the item, instruction manual, hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.
Please ask at your local community for the correct collection point.

Please retain this sheet and address for future use, as they contain important information.

4. Install 4 new 1.5V “AA” batteries with correct polarities (+/-)
as shown inside the battery compartment

5. Close the battery cover

6. Tighten the screw on the battery cover

Vehicle

Direction
Adjustment

Fig. 2

4. Install 1 new 9V battery with correct polarity (+/-) as shown inside the battery
compartment

5. Close the battery cover

6. Tighten the screw on the battery cover

7. Insert the antenna into the top of Transmitter, tighten it by rotating clockwise
(viewing from top of Transmitter)

Fig. 4

Transmitter

Transmitter
Antenna

Disposal of batteries

Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all
other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury

Battery
Compartment

ON/OFF Switch

Fig. 1 Fig. 3

Vehicle - Battery Installation

1.5V AA

1.5V AA

1.5V AA

1.5V AA

Forward /
Backward

How to Play

1. Switch ON the Vehicle

2. Use the Forward / Backward joystick (Fig.3) to drive the Vehicle forward and backward

3. Use the Left / Right joystick (Fig.3) to control the Vehicle turning left or right

4. If the vehicle does not run in straight line, adjust the wheel alignment lever on the vehicle chassis (Fig. 1)

5. Play on smooth surface to have the optimum performance

LED Battery
Indicator

Left / Right

OFF / ON

9 V

Battery

Transmitter - Battery installation

I

+

The packaging and instruction manual contain important information. Please keep them for future reference.
Warning! Choking Hazard. Not suitable for children under the age of 3 years due to small parts.
We reserve the right to improve/amend specifications and colors without notice.
Warning! The Antenna of vehicle is not to be inserted into socket outlets.

6. Remember to switch OFF the power of the Vehicle and Transmitter after playing

7. The optimum control range is up to 10m outdoor

Performance Tips

1. Do not drive on grass, dirt, sand, dusts, carpet or go through water

2. Do not drive in windy or rainy weather

3. Avoid direct impact the Vehicle with obstacles

4. Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter due to leakage of electrolyte from batteries

5. Remove all batteries from the Vehicle and Transmitter when not in use for long period

6. Keep fingers, hair and loose clothing away from wheels

7. The operating range can be affected by a variety of factors
a) Low Voltage of batteries in Transmitter or Vehicle
b) Interference from other items that emit radio frequency signals

8. Outdoor usage is recommended in order to get optimum control range

9. Recommend to play the vehicle on a clean and smooth surface

10. Clean the battery compartment to make sure it is free from dust to prevent poor contact of batteries

Trademarks used under license to

General Motors

Kidztech Toys Manufacturing LTD

99-151211-48621

Ford Motor Company Trademarks and

Trade Dress used under license to
KidzTech Toys Manufacturing Ltd.

KIDZTECH TOYS MANUFACTURING LTD.
Room 1201,12/F, Inter-Continental Plaza,
94 Granville Road, TST East, HK.
Tel: [phone] [e-mail]
Made in China http://www.kidztech.net

TOYOTA , FJ Cruiser and all other

associated marks,emblems and designs

are intellectual property rightsof Toyota

Motor Corporation and used with

permission.

KT9/11/11-00E