KIDZTECH TOYS 8741219 24GTX User Manual
NO.:
87412
573756056
PRO. SYSTEM
6
age
Contents
3 x AA
- RC T-Rex x 1
15
(49 feet)
- RC Transmitter (Transmitter) x1
- Water Rump x 1
RC Transmitter x 1
RC T-Rex x 1
1. Alkaline batteries are recommend to be used
2. Only batteries of the same or equivalent type as recommended are to be used
3. Do not mix alkaline, standard or rechargeable batteries
4. Do not mix old and new batteries or different type of batteries
5. Non-rechargeable batteries are not to be charged
6. If rechargeable batteries are to be used, they are only to be charged under adult supervision
7. Rechargeable batteries are to be removed from the product before they are charged
8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
9. Remove all batteries from the Vehicle and Transmitter when not in use
10. Exhausted batteries are to be removed from the product
11. The supply terminals are not to be short-circuited
12. Dispose of batteries properly / Do not dispose the batteries in fire - it may cause them to explode or leak causing injury or damage
13. Battery installation and removal must only be done by an adult
Battery Installation
For T-Rex (Fig. 1 and Fig. 2)
1. Switch OFF the power
2. Unscrew the screw on the battery cover
3. Open the battery cover
4. Install 3 new 1.5V”AA” batteries with correct polarities (+/-)
5. Close the battery cover
6. Tighten the screw on the battery cover
For Transmitter (Fig. 3 and Fig. 4)
1. Unscrew the screw on the battery cover
2. Open the battery cover
3. Install 2 new 1.5V “AA” batteries with correct polarities (+/-)
as shown inside the battery compartment
4. Close the battery cover
5. Tighten the screw on the battery cover
For T-Rex
(Included)
2 x AA
For Transmitter
(Not Included)
T-Rex
Fig. 1
T-Rex
Fig. 2
How To Fill In Water For Smoking Effect
1. Fill in clear water into the water purmp.
Fig. 5 Fig. 6
2. Open the cap of water tank on the T-Rex (Fig.5 and Fig.6)
Fig. 7 Fig. 8
Fig. 3
Move Forward
Transmitter
2.4 GHz
Signal light
Light, Sound
& Smoking
Effect
Fig. 4
Transmitter - Battery Installation
3. Fill in clear water to T-Rex by using the provided
water pump. (Fig.7)
4. Close the cap firmly. (Fig.8)
How To Bind
1. Turn on the T-Rex.
2. Hold the Signal Match Button for around 4 seconds then the Transmitter signal light will flash for 6-7 second.
3. After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing.
4. If it cannot complete within 8 seconds, please turn off the T-Rex and re-start the binding process.
5. When the binding process is done, whenever switching the T-Rex on and off, it searches for the code that it memorized and will only lock on to the
Transmitter signal containing that code.
6. Please turn off the T-Rex and re-start all binding process if changing to another 2.4GHz Transmitter for playing.
How To Play
1. Switch ON the T-Rex
T-Rex
ON/OFF
& Try me
2. Use the Transmitter to control the T-Rex move forward
Move Forward
Move
Forward
3. Use the Button for Light, Sound & Smoking Effect
Light, Sound &
Smoking Effect
Light, Sound
& Smoking
Effect
4. Play on a smooth surface for optimal performance
5. Remember to switch OFF the power of the T-Rex after
playing
6. The optimal control range is up to 15m(49 feet) indoor
87412
573756056
Performance Tips
1. Do not drive on grass, dirt, sand, dusts, carpet or go through water.
2. Do not drive in windy or rainy weather.
3. Avoid direct impact with obstacles.
4. Switch OFF the power when not in use to prevent damage of Vehicle due to leakage
of electrolyte from batteries.
5. Remove all batteries from the Vehicle and Transmitter when not in use for long period.
6. Keep fingers, hair and loose clothing away from wheels.
7. The operating range can be affected by a variety of factors
a) Low Voltage of batteries in Transmitter or Vehicle
b) Interference from other items that emit radio frequency signals.
8. Outdoor usage is recommended in order to get optimal control range.
9. Play with the vehicle on a clean and smooth surface.
10. Clean the battery compartment to make sure it is free from dust to prevent poor
contact of batteries
Cautions
1. Do not attempt to disassemble the Vehicle or Transmitter
2. Make sure the batteries are installed with correct polarities (+/-) as shown inside the
battery compartment
3. Remove the package and take out all accessories before giving the Vehicle and
Transmitter to child to play
The packaging and instruction manual contain important information. Please keep them
for future reference.
We reserve the right to improve/amend specifications and colors without notice.
FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RSS-210 Compliance Statement:
RSS-210 Compliance Statement:
This device complies with Industry Canada Licence-exempt RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
device must accept any interference, including interference that may cause undesired operation of the device.
Operation is subject to the following two conditions:
(1) This device may not cause interference.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Canada,. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Declaration of Conformity
The product is in conformity with the requirement of EU Directive 2014/53/EU.
Environmental notes:
The whole product also does not belong to household waste at the end of the product life.
You can return it at collection points for the recycling of electronic and electronical instruments
The symbol on the item, instruction manual, hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important
contribution to environmental protection.
Please ask at your local community for the correct collection point.
Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return
batteries containing harmful substances and all other used batteries. You can hand in your old batteries
at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing
harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury
Frequency band: 2405-2475 MHz
Maximum radio frequency
power transmitted: <0dBm
Conforms to the safety requirements of ASTM F963
Loading...