KIDZTECH TOYS 8419119 24GTX User Manual

1:14

SCALE

LIGHTING

EFFECT

NO.: 84191

8

ages

How To Bind

1. Turn on the Vehicle.

2. Keep pulling the trigger of the Transmitter forward then turn the Transmitter on. Do not release the trigger until the binding process completed.

3. The LED light of the Transmitter will keep flashing for the binding process, which is within 8 seconds. Do not turn off any buttons while in progress, otherwise,
the process will be terminated.

4. After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing.

5. If it cannot complete within 8 seconds, please turn off both Vehicle and Transmitter and re-start the bindingprocess.

6. When the binding process is done, whenever switching the Vehicle and Transmitter on and off, it searches for the code that it memorized, and will only lock on to
the Transmitter signal containing that code.

7. Please turn off both Vehicle and Transmitter and re-start all binding process if changing to another 2.4GHz Transmitter for playing.

How To Play

1. Switch ON the Vehicle andTransmitter.

3. Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward

Forward

Stop

Backward

84191

Vehicle Transmitter

ON OFF

Contents

-RC Vehicle (Vehicle) x 1

-RC Transmitter (Transmitter ) x 1

-Water pump x1

-Drifting wheels x4

-Screwdriver x1

-Instruction Manual x 1

-6.4V Rechargeable Battery Pack x1

-Charger x 1

-9V Battery x 1

1. The 6.4V Lithium Rechargeable Battery Pack must be charged before use by
utilizing the battery charger which included

2. Do not overcharge the battery pack. Do not charge for more than 6hours

3. Do not charge the battery pack if it shows leakage, corrosion, or has loose or
exposed wires or other damage

4. Do not cover the battery pack with any sort of materials while charging

5. Do not touch the battery pack when it is hot. Wait until the battery pack cools
before installing it in the Vehicle and before recharging

6. Do not dispose of the battery in fire

7. Do not dismantle the battery or charger, and do not cut the battery or charger
cables

8. The battery pack will be warm after charging, and hot after use in a vehicle

9. The supply terminals are not to be short-circuited

10. Rechargeable batteries are to be removed from the toy before being charged

11. Rechargeable batteries are only to be charged by adult.

12. Battery replacement must be only made by adults

13. The transformer (charger) is not a toy

30M /98FT
RANGE

RC Transmitter x1

Battery Installation

For Vehicle (Fig. 1 and Fig.2)

1. Switch OFF thepower

2. Unscrew the screw on the batterycover

3. Open the battery cover

4. Install 6.4V battery pack with correct polarities (+/-)
as shown inside the batterycompartment

5. Close the batterycover

6. Tighten the screw on the battery cover

Fig. 2

L R

MustangGT4

Direction
Adjustment

Battery
Compartment

ON/OFF

Fig. 1

Vehicle

ON OFF

LR

KIDZTECHTOYS
MADE INCHINA

MustangGT4

6.4

V

ONOFF

Vehicle - BatteryInstallation

Water pumpx1

Screwdriverx1

9V

6.4 V

Drifting wheelsx4

RC Vehicle x1

14. Charge only type (1300mAh Max.) rechargeable battery packs. Other types of
batteries may burst causing injury to persons and damage. This power unit is
intended to be correctly orientated in a vertical or floor mount position. This
charger is intended to be used for charging 6.4V lithium rechargeable battery
pack with capacity 1300mAh Max. It cannot be used for charging
non-rechargeable batteries. Regular examination of battery charger for any
damage to their cord, plug, enclosure and other parts, and that, in the event of
such damage, it must not be used with the charger or battery pack charge
until such damage has been repaired. Note that the 9V battery is
non-rechargeable and is not to be recharged. Only batteries of the same or
equivalent type as recommended are to be used. It will need replacement
when transmission is poor.

15. Exhausted batteries are to be removed from the product.

Cha rgi ng the Rech argeab le Ba tte ry Pa ck for the Vehi cle:

1. Connect the 6.4V lithium rechargeable battery pack to the batterycharger

2. Plug the charger into the standard AC socket

3. The charging time for a full charge is about 3hours

4. When charging is completed, unplug the charger from the ACsocket

5. Disconnect the rechargeable battery pack form the batterycharger

For Transmitter (Fig. 3 and Fig. 4)

1. Unscrew the screw on the batterycover

2. Open the battery cover

3. Install 1 new 9V battery with correct polarity (+/-) as shown inside the battery
compartment

4. Close the batterycover

5. Tighten the screw on the batterycover

ON/OFF
(AtR ear)

Fig. 3

Transmitter

Accel erator
Trigg er

LED Ba tter y
Indic ator

Steer ing
Wheel

Transmitter - BatteryInstallation

Fig. 4

PRO . S Y S TEM

1 X 9V Battery
For Transmitter
(Included)

6.4 V
130 0mAh
For Vehicle
(Included)

ADAPTE R
(Included)

9V

Batter

y

+

I

4. If the vehicle does not run in straight line, adjust the

2. Use the Steering Wheel to control the Vehicle turning left or right

Turn Left Turn Right

Direction Adjustment on the Vehicle chassis

5. Play on smooth surface to have the optimumperformance

6. Remember to switch OFF the power of the Vehicle and
Transmitter after playing

7. The optimum control range is up to 30m outdoor

How To Fill In Water For Smoking Effect

1. Fill in clear water into the water pump.

Fig. 5 Fig. 6

Water tank cap

2. Open the cap of water tank on the vehicle. (Fig.5 and Fig.6)

Fig. 7 Fig. 8

3. Fill in clear water to vehicle by using the provided
water pump. (Fig.7)

4. Close the cap firmly. (Fig.8)

How To Change To The Drifting Wheels

1. Unscrew the screws of the rubber wheels on thevehicle.

2. Remove the screws and the wheels from the vehicle.

3. Install the drifting wheels into thevehicle.

4. Tighten the screws on thewheels.
Note: Changing wheels needs to be processed or supervised by the adult.

Vehicle - Drifting Wheels Installation

84191

84191

Performance Tips

1. Do not drive on grass, dirt, sand, dusts, carpet or go through water.

2. Do not drive in windy or rainy weather.

3. Avoid direct impact the Vehicle with obstacles.

4. Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter
due to leakage of electrolyte from batteries.

5. Remove all batteries from the Vehicle and Transmitter when not in use for long period.

6. Keep fingers, hair and loose clothing away from wheels.

7. The operating range can be affected by a variety offactors
a) Low Voltage of batteries in Transmitter or Vehicle
b) Interference from other items that emit radio frequency signals.

8. Outdoor usage is recommended in order to get optimum control range.

9. Recommend to play the vehicle on a clean and smooth surface.

10. Clean the battery compartment to make sure it is free from dust to prevent poor
contact of batteries

FCC label compliance statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequenc y energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for help

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Declaration of Conformity

The product is in conformity with the requirement of EU Directive 2014/53/EU.

Environmental notes:

The whole product also does not belong to household waste at the end of the product life. You
can return it at collection points for the recycling of electronic and electronical instruments The
symbol on the item, instruction manual, hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important
contribution to environmental protection.
Please ask at your local community for the correct collection point.

Disposal of batteries

Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to
return batteries containing harmful substances and all other used batteries. You can hand in your old
batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing
harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury

Cautions

1. Do not attempt to disassemble the Vehicle or Transmitter

2. Make sure the batteries are installed with correct polarities (+/-) as shown inside the
battery compartment

3. Remove the package and take out all accessories before giving the Vehicle and
Transmitter to child to play

The packaging and instruction manual contain important information. Please keep them
for future reference.
Warning! Choking Hazard. Not suitable for children under the age of 3 years due to
small parts.
We reserve the right to improve/amend specifications and colors without notice.

Ford Trademarks and Trade Dress
used under license to KidzTech Toys
Manufacturing Ltd.

Frequency band: 2407-2475 MHz

Conforms to the safety requirements of ASTMF963

KI D ZT EC H TO YS M AN UF AC T UR IN G L TD .
Ro o m 12 01, 12/ F, I nte r-C on tin ent al P laz a,
94 Gr anv ill e R oa d, T ST E ast , H on g Ko ng.
Tel : ( 852 ) 2 72 18 86 8 in fo @ki dzt ech .n et
Ma de i n C hi na h ttp ://w ww. kidz te ch. ne t

KT-Burnoutz-20181011-EN