KIDZTECH TOYS 8408719 24GTX User Manual

Contents

6. Tighten the screw on the battery cover

LED Battery

ON/OFF

Steering

Trigger

Vehicle

- Battery Installation

Battery

ON/OFF

Adjustment

)

-RC Vehicle (Vehicle) x 1

-RC Transmitter (Transmitter ) x 1

-Instruction Manual x 1

-9.6V Rechargeable
Battery Pack x 1

-Charger x 1

-AAA Batteries x 3

NO.: 84087

40M
RANGE

RC Transmitter x 1

RC Vehicle x 1

9.6V

3 x AAA
For Transmitter
(Included)

9.6V
1300mAh
For Vehicle
(Included)

ADAPTER
(Included)

Battery Precaution

1. The 9.6V Lithium Rechargeable Battery Pack must be charged before use by
utilizing the battery charger which included

2. Do not overcharge the battery pack. Do not charge for more than 6 hours

3. Do not charge the battery pack if it shows leakage, corrosion, or has loose or
exposed wires or other damage

4. Do not cover the battery pack with any sort of materials while charging

5. Do not touch the battery pack when it is hot. Wait until the battery pack cools
before installing it in the Vehicle and before recharging

6. Do not dispose of the battery in fire

7. Do not dismantle the battery or charger, and do not cut the battery or charger
cables

8. The battery pack will be warm after charging, and hot after use in a vehicle

9. The supply terminals are not to be short-circuited

10. Rechargeable batteries are to be removed from the toy before being charged

11. Rechargeable batteries are only to be charged by adult.

Battery Installation

For Vehicle (Fig. 1 and Fig. 2)

1. Switch OFF the power

2. Unscrew the screw on the battery cover

3. Open the battery cover

4. Install 9.6V battery pack with correct polarities (+/­as shown inside the battery compartment

5. Close the battery cover

6. Tighten the screw on the battery cover

Vehicle

12. Battery replacement must be only made by adults

13. The transformer (charger) is not a toy

14. Charge only type (1300mAh Max.) rechargeable battery packs. Other types of
batteries may burst causing injury to persons and damage. This power unit is
intended to be correctly orientated in a vertical or floor mount position. This
charger is intended to be used for charging 9.6V lithium rechargeable battery
pack with capacity 1300mAh Max. It cannot be used for charging
non-rechargeable batteries. Regular examination of battery charger for any
damage to their cord, plug, enclosure and other parts, and that, in the event
of such damage, it must not be used with the charger or battery pack charge
until such damage has been repaired. Note that the AAA battery is
non-rechargeable and is not to be recharged. Only batteries of the same or
equivalent type as recommended are to be used. It will need replacement
when transmission is poor.

15. Exhausted batteries are to be removed from the product.

Charging the Rechargeable Battery Pack for the Vehicle:

Connect the 9.6V lithium rechargeable battery pack to the battery charger
Plug the charger into the standard AC socket
The charging time for a full charge is about 3 hours
When charging is completed, unplug the charger from the AC socket
Disconnect the rechargeable battery pack form the battery charger

For Transmitter (Fig. 3 and Fig. 4)

1. Switch OFF the power

2. Unscrew the screw on the battery cover

3. Open the battery cover

4. Install 3 new AAA batteries with correct polarity (+/-) as shown inside the battery
compartment

5. Close the battery cover

Fig. 4

Direction

Compartment

Indicator

9.6V

(At Rear)

Accelerator

Wheel

Keep driving forward rapidly then switch to backward for the braking action. When the trigger

of the Transmitter returns to the center position, push it again for the backward action.

2. Use the Steering Wheel to control the Vehicle turning left or righ

t

Backward

Stop

Forward

3. Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward

Trouble shooting for 2.4GHz pairing in case of no signal

1. Switch OFF the Vehicle and Switch ON to re-start.

2. Re-install the batteries of transmitter and Switch ON to re-start.

3. The transmitter signal light will flash for 7-8 seconds.

4. After the LED light of the transmitter stops flashing, the pairing process is complete for playing.

5. If pairing cannot be completed within 8 seconds, please turn off the Vehicle and re-start the pairing process.

6. When the pairing process is done, whenever switching the Vehicle on and off, it searches for the code that is memorized and will only lock on to the
transmitter signal contained that code.

7. If the battery power is low or the LED light of the Transmitter keeps flashing when playing, please replace the new batteries.

How To Play

1. Switch ON the Vehicle and Transmitter.

Vehicle

Transmitter

Turn Right Turn Left

4. If the vehicle does not run in straight line, adjust the
Direction Adjustment on the Vehicle chassis

5. Play on smooth surface to have the optimum performance

6. Remember to switch OFF the power of the Vehicle and
Transmitter after playing

7. The optimum control range is up to 40m outdoor

Braking Action

84087

Performance Tips

1. Do not drive on grass, dirt, sand, dusts, carpet or go through water

2. Do not drive in windy or rainy weather

3. Avoid direct impact the Vehicle with obstacles

4. Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter
due to leakage of electrolyte from batteries

5. Remove all batteries from the Vehicle and Transmitter when not in use for long period

6. Keep fingers, hair and loose clothing away from wheels

7. The operating range can be affected by a variety of factors
a) Low Voltage of batteries in Transmitter or Vehicle
b) Interference from other items that emit radio frequency signals

8. Outdoor usage is recommended in order to get optimum control range

9. Recommend to play the vehicle on a clean and smooth surface

10. Clean the battery compartment to make sure it is free from dust to prevent poor
contact of batteries

FCC label compliance statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for help

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Declaration of Conformity

The product is in conformity with the requirement of EU Directive 2014/53/EU

Environmental notes:

Disposal of batteries

The whole product also does not belong to household waste at the end of the product life.
You can return it at collection points for the recycling of electronic and electronical instruments
The symbol on the item, instruction manual, hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important
contribution to environmental protection.
Please ask at your local community for the correct collection point.

Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to
return batteries containing harmful substances and all other used batteries. You can hand in your old
batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing
harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury

Frequency band: 2408-2475 MHz

Maximum radio frequency
power transmitted: <0dBm

KIDZTECH TOYS MANUFACTURING LTD.
Room 802, 8 /F, Inter-Cont inental Plaza,
94 Granville Road, TST East, Hong Kong.
Tel: [phone] info@kidztec h.net
Made in China http://www.kidztec h.net

US OFFICE:
1540 Forest Avenue,
River Forest, IL 60305, USA
Tel: [phone] Fax: [phone]

KT-TopMaz-08/07/2019-EN