Kiddicare Chloe Instruction Manual
Chloe
Cot bed
Kiddicare
Club Way,
Cygnet Park,
Hampton,
Peterborough,
Cambridgeshire PE7 8JA
Customer Care: hello@kiddicare.com
care
Safety
Warning: Do not use the cot if any part is broken, torn or missing and use only spare parts approved by
the manufacturer.
Warning : Do not leave anything in the cot or place the cot close to another product, which could provide
a foothold or present a danger of suocation or strangulation, e.g. strings, blind/curtain cords, etc.
Warning: Do not use more than one mattress in the cot.
Warning: Be aware of the risk of open res and other sources of strong heat, such as electric bar res, gas
res, etc. near the vicinity of the cot.
• The base can be adjusted in height in cot mode, but the lowest position is the safest and should
always be used in that position as soon as the baby is old enough to sit up.
• This product is suitable for a mattress of 1400mm in length and 700mm in width.
• The length and width of the mattress shall be no less to ensure the gap between the mattress and
the sides and ends does not exceed 30mm.
• The thickness of the mattress shall be such that the internal height (surface of the mattress to the
upper edge of the cot frame) is at least 500mm in the lowest position of the cot base and at least
200mm in the highest position of the cot base.
• The bed mode is suitable for a child from 18 months old to 4 years old.
• Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed should not
be placed too close to other furniture or windows, blind cords, curtain pulls or other strings or
cords. It should be placed either tight to any wall or have a gap of 300mm between the wall and
the side of the bed.
• The bed can be carefully dismantled for storage and transportation.
• To prevent injury from falls the cot should no longer be used for the child once they are able to
climb out of the cot.
•
This product conforms to: BS EN 716-1: 2008 + A1: 2013 and BS 8509: 2008 + A1: 2011
Maintenance
All assembly ttings should be tightened properly and should be checked regularly and
re-tightened as necessary.
Cleaning
Your cot can be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia based household polishes.
IMPORTANT:
KEEP FOR FUTURE REFERENCE,
READ CAREFULLY
10 20 30 40 50 60 70 80 90 1000
(millimeters)
2
parts
ttings
Measure
1a x2
1b x2
2 x 2
3 x1
A x 16
B x 16
C x 1
1b
3
C
A
B
1a
I
A
A
B
bed base positions
II
I
assembly
3
1
1
1
60 mm
B
B
A
1a
1b
III
II
III
Loading...