ANGELINA
COT BED
IMPORTANT
RETAIN FOR FUTURE REFERENCE:READ CAREFULLY
A x 2
The help of an
assistant will aid
assembly
PLEASE DISPOSE OF PACKAGING MATERIAL.
PLASTIC BAGS CAN BE DANGEROUS TO YOUNG CHILDREN
B x 2
C
D x 12 E x 12 F x 1
COT ASSEMBLY
4 x E
each end
4 x D
each end
2 x B
D
D
D
D
E
E
E
The dowel nuts (parts E) t into the holes in the sides and base.
The slot on one end of the nut indicates the direction of the
threaded hole and should be visible when the nut is inserted.
It is advisable to push each nut into its hole and check for
correct alignment before inserting any screws
A
A
Do not fully tighten screws at this stage
2 x E
each end
2 x D
each end
BED ASSEMBLY
2 x A
C
2 x D
each end
Choose 1 of 3 positions
4 x E
C
E
E
E
E
When assembly has been completed, fully tighten all screws.
WARNING: Do not place this child’s bed near heat sources, windows and other furniture.
WARNING: Do not use this child’s bed if any of the parts are broken, torn or missing.
IN USE
WARNING: YOUR CHILDREN’S SAFETY IS YOUR RESPONSIBILITY
CARE AND MAINTENANCE
The base can be adjusted in height in cot mode, but the lowest position is the safest and should
always be used in that position as soon as the baby is old enough to sit up.
This product is suitable for a mattress of 1400mm in length and 700mm in width. When used in
cot mode, the maximum thickness of the mattress is 100mm.
The length and width of the mattress shall be no less to ensure the gap between the mattress
and the sides and ends does not exceed 30mm.
The thickness of the mattress shall be such that the internal height (surface of the mattress to
the upper edge of the cot frame) is at least 500mm in the lowest position of the cot base and at
least 200mm in the highest position of the cot base.
To prevent injury from falls the cot should no longer be used for the child once they are able to
climb out of the cot.
The bed mode is suitable for a child from 18 months to 4 years.
Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed should not
be placed too close to other furniture or windows, blind cords, curtain pulls or other strings or
cords. It should be placed, either tight to any wall or have a gap of 300mm between the wall and
the side of the bed.
All assembly fittings should be tightened properly and should be checked regularly and
re-tightened as necessary.
To clean use a damp cloth, avoiding the use of strong detergents or abrasives.
An occasional light application of a wax polish will help maintain a good appearance.
This product complies with BS EN 716-1: 2008 and BS 8509: 2008 + A1: 2011
Warning: Do not use the cot or bed if any part is broken, torn or missing and use only spare
parts approved by the manufacturer.
Warning: Do not leave anything in the cot or place the cot close to another product, which could
provide a foothold or present a danger of suffocation or strangulation, e.g. strings, blind/curtain
cords, etc.
Warning: Do not use more than one mattress in the cot.
Warning: Be aware of the risk of open fires and other sources of strong heat, such as electric bar
fires, gas fires, etc. near the vicinity of the cot.
WARNING: Do not place the child’s bed near heat sources, windows and other furniture.
This product can be carefully dismantled for storage and transportation.
Customer care hotline for this product 01692 408802
kiddicare.com
Club Way
Cygnet Park
Hampton
Peterborough
Cambs
PE7 8JA
www.kiddicare.info
07798
Loading...