Kidde Safety Europe Ltd CV3106 User Manual

UK

USER

GUIDE

2. NORMAL MODE:

In normal mode the LED will ash every 48 sec­onds to show correct operation.

3. ALARM MODE:

When a rapid and constant change of tempera­ture is detected, the heat alarm will go into ‘Alarm
Mode’. It will sound the alarm signal and the LED
will ash.

Disposal: Battery not replaceable. Please dispose
properly at the end of life. This is electronic waste
which should be recycled.

The heat alarm is not suitable for use as a re
safety device unless it is part of a planned re

safety system, i.e. when interconnected to one or
more smoke alarm(s).

Complies to the Radio Equipment Directive
2014/53/EU

Thermal heat alarm device
Commercial reference: 3106-008
Developed by CAVIUS

This Thermal Heat Alarm is designed for areas not
suitable for smoke alarms due to high risk of false
alarms such as; kitchens, garages or workshops.

PLEASE READ THE USER GUIDE CAREFUL­LY BEFORE INSTALLATION AND RETAIN
FOR FUTURE USE.

SAFETY INSTRUCTIONS:
The device comes with a 3V lithium battery. Bat­teries are to be handled with care and battery pow­ered devices should be kept out of reach of chil-

dren. Do not try to recharge or burn the batteries.

The maximum number of alarms that can be inter-

linked within a house group are 32.

Please note: These must be alarms from the CAVIUS

1. TEST FUNCTION:

After installation, and at least once per quarter,

test all of your alarms to ensure they are operating
correctly and are within range of each other.

It is recommended to check visually every week if

the LED ashes correctly (every 48sec.)

Press the test button on any alarm for 2
sweeps of alarm signal 1 (--- --- ---) - Please
refer to section 3. This will send out a test sig­nal from the alarm; all other connected alarms
should receive the signal within a short time.
The alarms will emit a short beep and the LED

will ash every 8 seconds for 2 minutes.

NOTE: Test function also allows to send a depleted

RF signal to ensure an optimal operation in normal

conditions.

When the test signal is sent out, the alarms will

respond in two ways:

1. A single beep every 8 seconds indicates that the
alarms are connected and functioning.

2. Three short beeps every 8 seconds indicates a
heat sensor fault.

If required this indication can be stopped early on
each alarm by a short press of the test button.

If the problem continues, please visit www.cavius.

com for any trouble shooting.

The heat alarm will also transmit the alarm sig-

nal to the other connected alarms, which will also

sound the alarm signal after a short delay.

The CAVIUS Wireless Family have two different

alarm signals:

Alarm signal 1 (--- --- ---) is life threatening

alarms.

Alarm signal 2 (- - -) is a non life threatening

alarm.

Smoke alarm signal: --- --- --­Heat alarm signal: --- --- ---

Please note that only the originating alarm’s LED
will ash, so it can be identied.

4. PAUSE/HUSH FUNCTION:

If the heat alarms are to set into a false alarm

by cooking, replace, etc. they can be paused
for 10 minutes by pressing the test button on
the originating heat alarm only (indicated by the
ashing LED).

Test/hush button

NOTE: The reason of this is that it is necessary
to locate the source of the alarm before using the
hush function. This is to make sure that it is not a
life threatening situation.

5. LOW BATTERY SIGNAL:

Your product has a 10Y battery life.

When the battery is starting its end of life, a short

beep will sound out every 48 seconds for 30 days.

The alarm effected by the low battery will only
beep, no other connected alarms will sound.

6. TROUBLE SHOOTING:

If you are experiencing false alarms with just general
cooking, you may have your heat alarm too close
to the cooking hobs and stove. Try reinstalling
slightly further away to alleviate any issues.

If the heat alarm does not work when the test
button is pushed, the probable cause is a power
failure.

If the problem continues, please visit www.cavius.

com for any trouble shooting.

7. OTHER INFORMATION:

Do not paint the alarm.

RF frekvens: 868 MHz.

Maximum radio-frequency power transmitted: 20
dBm

Full DoC to 2014/53/EU (RED) can be download­ed at www.cavius.com

WARNING: All alarms should be assumed as due
to actual re and the dwelling should be evacuat­ed immediately.

WARNING: To prevent injury, this apparatus must
be securely attached to the ceiling/wall in accor­dance with the installation instructions.

WARNING: Batteries shall not be exposed to ex-

cessive heat such as shine, re, or the like.

Note the local country regulations regarding

installation.

The CE mark afxed to this product conrms its

compliance with the European Directives which
apply to the product.
Tested to comply to the standard of system heat
alarms EN54-5 class A1.

Alarm condition aural signal pattern according to

ISO 8201.

BSI Kitemark™ certied.

KM 737251

BS 5446-2:2003

A1 3106-008

All Rights reserved: Cavius Aps assumes no

responsi bility for any errors, which may appear
in this manual. Furthermore, Cavius Aps reserves

the right to alter the hardware, software, and/or
specications detailed herein at any time without

notice, and Cavius Aps does not make any
commitment to update the infor mation contained
herein. All the trademarks listed herein are owned

by their respective owners. Copy right © Cavius Aps.

Developed by CAVIUS Aps Julsøvej 16, DK-8600
Manufactured in P.R.C.

Contact: CAVIUS Ltd, Edinburgh, Scotland, EH3

9DQ
Tel: [phone], www.cavius.com

400133 rev3