KICSYSTEMS U9-4100 User Manual
1
KICSYSTEMS U9-4100
User Manual
(Ver 2012.07.19)
2
Table of Contents
• 1. Directions
General Safety Notes
Directions for Carrying and Storage
Directions for Using the Battery
• 2. Product Components
Main Specification
Content
Product Appearance
Explanatory Notes on the Individual Parts
Installing and Removing the Battery
• 3. Getting Started
Power On/Off
Checking the Battery
Backlight Control
Tou c h C or rec t io n
Date and Time Setup
Sounds Setup
WLAN
Bluetooth
Using Active Sync
Directions for using Active Sync
Rebooting the Unit
Initializing the Unit
• 4. Main Functionalities
RFID
Barcode
Camera
• 5. Additional Functionalities
SystemTray
SmartUi
Image Viewer
Calculator
Recorder
Picture Memo
• 6. Application Program
• Updating Default S/W
• Setting the SystemTray IP
3
1. Directions
General Safety Notes
• Users that have taken CDMA additional options are
requested to report to communication common carrier in
case of losing the unit.
• Renting the device to a stranger must be avoided.
• The use of the device should be limited while driving.
• To receive A/S, contact the number indicated for purchase
at the back of User Manual.
• About inquiries for optional applications besides the
hardware or basic software embedded in the unit, contact
directly to a relevant production company.
• Only the designated battery and adaptor must be used.
• The manufacturer accepts no liability of providing A/S for
defects caused by a user that is undesignated or
unregistered for a certain product.
Directions for Carrying and Storage
• The unit must not be placed in a high heat and a damp
environment, which may cause a fatal damage or
unexpected problem.
• Giving a shock such as dropping the unit from the heights
be avoided. It may result in a fatal damage to the device.
• Opening the unit or making modifications must not be
taken. Such actions may result in electric shocks and
damages of the unit.
• Modifications to the unit make the manufacturer’s
warranty for A/S null and void.
• The unit must not be used in a insufficiently ventilated
place where inflammable and explosive gases exist. There
is a risk of fire and explosion.
• Users must avoid to let metals and inflammables be
inserted or to purposely insert those materials in the
interfacing part of the SD memory of the unit. Such
actions cause a fire or electric shocks.
• Operating the unit with wet hands may result in electric
shocks.
• Barcode Scanner’s rays must not be rayed directly to
human eyes. There is a risk of damaging sights.
• The unit should be kept out of the reach of infants and
children.
• If using the portable RFID reader for extended periods,
its internal and the battery’s temperatures increase.
With a high heat, the device may stop.
• The unit must not be left in a car with insufficient
ventilation or in a place with direct rays. Such actions
result in damaging components inside or the
appearance of the unit, which may cause a fire.
4
• Only the designated battery must be used. Using other
batteries has a risk of fire or explosion.
• Be aware that metals such as steel wires or hairpins are
not to be attached to an electric contact of the battery.
• Separate the battery, if not using the unit for a long time.
If the battery’s liquid leaks and gets into the unit,
components inside could be fatally damaged.
• Be aware battery short-circuit when separating the battery
from the unit.
• Disassembling the battery must be avoided. It may cause
leaks or explosion.
• If the battery’s liquid gets in eyes, do not rub but wash off
with clean water. The person is requested to contact his or
her doctor due to the risk of losing eye sight.
• In case of doubt for problems like a smoke coming out
from the battery, separate the battery immediately at a
safe place. When disjoining the battery, take caution in
order to avoid burns. Users that have a battery with
problems are advised to contact where it was originally
purchased.
• Battery is expendables. Repeating charging and
discharging shortens the life of the battery. Users are
recommended to purchase a new battery when the life of
the old battery is a half left.
• The Battery pack can be over-discharged and then be
unusable due to the long-term use. Before keeping the
battery on file, perform “Hard Reset” and then detach the
main battery for storage.
• The battery should be kept in a place under dry and
low temperature of 20 degrees Celsius or below. And,
the battery should be charged every 2~3 months.
• The main battery and sub-battery pack are both
expendables and have a lifecycle. Replacement of the
battery is recommended after a certain time.
• Only a designated charger to the unit must be used.
• Users are requested to use the device only at the stated
supply voltage or power supply unit. If the supply
voltage is wrong, there is a risk of fire and electric
shocks.
• Users that have a charger with problems are advised to
contact where it was originally purchased. Using it may
cause a fire or electric shocks.
• If it lightens and thunders, remove the power plug and
the unit should not be used. It may cause a damage of
the unit, a fire or electric shocks.
• Foreign substances like dirt should be cleaned off the
power plug. Those substances may cause a fire.
• The battery pack can be discharged if not using the
PDA for extended periods, if keeping the battery
equipped for extended periods and not using it on the
process of program development. In this case, the
battery can become unusable. Users are requested to
charge the battery pack once every 2~3 months.
Directions for Using the Battery
1. Directions
5
2. Product Components
Main Specification
Items Details Notes
Main System
Processor Samsung S5PV210 ( Cortex-A8 ) Max 1.0 Ghz
OS Windows Embedded CE 6.0 R3
Memory DDR2 SDRAM 512 MB
Storage NAND Flash Memory 256 MB
Display Display 240 * 320 Pixel 3.5 Inch TFT LCD 4Wire Touch Interface
Module
RFID Reader 900Mhz UHF RFID Reader Module EPC GEN2 ISO-18000-6B,6C 860~960Mhz
Barcode Scanner Barcode 1D / 2D Honeywell IM-5000
Camera 3M CMOS
WIFI 802.11 b/g
Bluetooth Bluetooth 2.0 + EDR MOVON MD-6RF
I/O Device
Keypad Keypad ( Front 20 key, Side 3 Key )
Audio Speaker( AMP ), Earphone( 2.5mm Stereo ) Speaker 2W
Connector TTA24 USB, UART, Power Active Sync, Charging
Battery Battery Lithium-ion 5200mAH (2CELL 2600mAH)
Environment
Characteristics
Storage Temp -10℃ to 60℃
Humidity 95%
Drop Spec 1.5m IP65
Dimensions 163mm * 38mm * 75mm (W * D * H)
6
[ Main Body ]
[ Desk Cradle] [ Battery ] [ Stylus Pen]
[ Adaptor ] [ USB Cable ]
[ SDK CD]
Content
* Images contained in User Manual may be different
from the actual images of the original product.
2. Product Components
7
[ The Right
Side ]
[ The Front ] [ The Back ] [ The Left
Side ]
[ The Bottom ]
[ The Top ]
Product Appearance
* Images contained in User Manual may be different
from the actual images of the original product.
2. Product Components
8
[ The Back ]
[Battery]
[RFID Antenna]
Explanatory Notes on Parts
* Images contained in User Manual may be different
from the actual images of the original product.
2. Product Components
[ The Front ]
[Power LED] [Speaker]
[RFID/CDMA Status LED]
[3.5’ LCD]
[Keypad]
[Microphone]
9
[ The Right Side ]
[ The Left Side]
[Earphone Jack]
[Function Key]
[Reset Button]
[ SD Card Slot]
[Function Key]
[Hand Strap]
* Images contained in User Manual may be different
from the actual images of the original product.
[Function Key]
Product Components
Explanatory Notes on Parts
10
[ The Bottom ][ The Top ]
[Charge Cables Connection Terminal][ 3M Camera ][1D/2D Barcode]
* Images contained in User Manual may be different
from the actual images of the original product.
Explanatory Notes on Parts
2. Product Components
11
[ The Back ][ The Front ]
[ Power ]
[UART]
[USB]
[Power LED]
* Images contained in User Manual may be different
from the actual images of the original product.
Explanatory Notes on Parts
2. Product Components
Loading...