Kicker HS12L7, HS12L5 User Manual

HS12L5 / HS12L7

REAR HATCH
or TRUNK

Move enclosure around and mount it
where it sounds best to you.

FRONT

Sealed Enclosure Systems

Congratulations! You have just purchased one of the most advanced
subwoofers in the history of car audio. Your KICKER Solo-Baric is the latest
in KICKER s trend-setting Solo-Baric line, designed and engineered to
deliver the ultimate in low bass performance and unmatched durability.
Thanks for buying KICKER

Installation Instructions

These enclosures combine KICKER’s award-winning Solo-Baric subwoofers
with computer designed and human-fine-tuned enclosures. They offer a
level of bass performance never before thought possible from a commer­cially available enclosure. The HS Series enclosures are covered in a
Polyurethaane

SL7

woofer.

KICKER HS enclosures are engineered to provide the best bass response

when mounted in the rear hatch or trunk.

for protection and pre-loaded with either a Solo-Baric

. Enjoy.

S

Caataalyzed

SL5

or

Specifications

MModel

HHSS1122LL55

HHSS1122LL77

NOTE:

*The two ohm unit should be used with the KX Series Class D amplifiers KX550.3, KX700.5, KX400.1,

and KX600.1. It is not recommended for use with any KX two or four channel amplifiers.

The four ohm unit should be used with any KX Series two or four channel amplifier. It is not rec-

ommended for use with any KX Series Class D amplifiers.

Woofer Imp. Power Top Bottom Height Width

S12L5 *2,4 600 77-11/16,19.53

S12L7 *2,4 750 77-11/16,19.53

Handling Depth Depth

(Watts) (In., cm) (In., cm) (In., cm) (In., cm)

1144

, 35.56

1144

, 35.56

1144

-5/8, 37.15

1144

-5/8, 37.15

1166

1166

, 40.64

, 40.64

Mounting

After determining the best mounting position, check carefully in the areas
where the mounting brackets will go. Make very sure that the mounting
screws will not puncture the gas tank, brake lines, wire harnesses, etc., or
interfere with any mechanical items on the underside of the chosen mount­ing surface. Turn the enclo­sure upside-down and attach
the four mounting brackets
to the bottom of the enclo­sure using the supplied small­er screws. Each bracket must
be positioned so the rounded
end protrudes approximately
3/4" from under the cabinet
to allow a screw to easily pass
through it for attachment to
the vehicle.(See Diagram.)

Plug your subwoofer
speaker wire into the termi­nals, using the red connector
as positive and the black con­nector as negative. Hook the
other end of this wire to your
subwoofer amplifier in accordance with its owner's manual. This enclosure is
wired internally to produce a 2 or 4 Ohm load at the terminals depending on
the model.

With the enclosure right side up, securely attach it to the vehicle with the
supplied larger screws. If the supplied hardware is not applicable to your
installation, some other means of securely attaching the enclosure to the
vehicle must be used.

To avoid potential injury from forward movement of the enclosure
during abrupt stops or accidents, this enclosure must be properly
installed and securely fastened to your vehicle.

2

SPEAKER SYSTEMS LIMITED WARRANTY

Stillwater Designs warrants this product to be free from defects in material and workmanship under

normal use for a period of one (1) year from date of original purchase from an authorized
Kicker Dealer, unless this product is labeled “B Stock”, in which case it is warranted for ninety (90) days
from date of purchase. Should service be necessary under this warranty for any reason due to manufac­turing defect or malfunction during the warranty period, Stillwater Designs will replace or repair (at its
discretion) the defective merchandise with equivalent merchandise at no charge. Warranty replacements
on “B-Stock” may have cosmetic scratches and blemishes. Discontinued products may be replaced with
equivalent products.

This warranty is valid only for the original purchaser and is not extended to owners of the product

subsequent to the original purchaser. Any applicable implied warranties are limited in duration to a period
of the express warranty as provided herein beginning with the date of the original purchase at retail, and
no warranties, whether express or implied, shall apply to this product thereafter. Some states do not
allow limitations on implied warranties, therefore these exclusions may not apply to you.

This warranty gives you specific legal rights; however you may have other rights that vary from state to

state.

WHAT TO DO IF YOU NEED WARRANTY OR SERVICE

Defective merchandise must be returned to your local Authorized Stillwater Designs (Kicker) Dealer for
warranty. Assistance in locating an Authorized Dealer can be obtained by writing or calling Stillwater
Designs direct. You can confirm that a dealer is authorized by asking to see a current authorized dealer
window decal.

If it becomes necessary for you to return defective merchandise, call the Kicker Customer Service
Department at [phone] for a Return Authorization (RA) number. Package all defective items in the
original container or in a package that will prevent shipping damage, and return to

Stillwater Designs, 5021 North Perkins Road, Stillwater, OK 74075

The RA number must be clearly marked on the outside of the package. Return only defective compo­nents. Return of entire cabinets, system packs, pairs, etc. increases your return freight charges. Non­defective items received will be returned freight collect.

Include a dated proof-of-purchase from an Authorized Dealer. Warranty expiration on items
returned without proof-of-purchase will be determined from the manufacturing date code. Coverage
may be invalidated if this date is greater than 18 months previous to the date item is sent in. Freight
must be prepaid; items received freight collect will be refused.

Failure to follow these steps may void your warranty. Any questions can be directed to the Kicker
Customer Service Department at [phone].

WHAT IS NOT COVERED?

This warranty is valid only if the product is used for the purpose for which it was designed.
It does not cover:

• Install slips (screwdriver holes)

• Damage caused by exposure to water

and/or excessive heat.

• Damage through negligence, misuse, or

accident.

• Items physically damaged due to abuse.

• Freight damage.

• The cost of shipping product to Stillwater

Designs Service.

• Items previously repaired by any
unauthorized repair facility.

• Items returned from unauthorized
individuals or dealers.

• Return shipping on non-defective items.

• Speakers damaged due to amplifier
clipping or distortion.

• Speakers with silicon caulk used for gasket
material.

HOW LONG WILL IT TAKE?

Stillwater Designs maintains a goal of 24-hour service for all returns. Delays may be

incurred if lack of replacement inventory or parts is encountered.

INTERNATIONAL WARRANTY

Contact your International Stillwater Designs dealer or distributor concerning specific

procedures for your country’s warranty policies.

P.O. Box 459 • Stillwater, Oklahoma 74076 • U.S.A. • 405 624-8510

KICKER drivers are capable of producing sound levels that can permanently
damage your hearing! Turning up a system to a level that has audible distor­tion is more damaging to your ears than listening to an undistorted system at
the same volume level. The threshold of pain is always an indicator that the

WARNING:

sound level is too loud and may permanently damage your hearing.
PPleaase use common sense when controlling volume!!

June 2002