Kicker HCVR12 Owner's Manual

HCVR12
REAR HATCH or TRUNK
Move enclosure around and mount it where it sounds best to you.
FRONT
Sealed Enclosure Systems
Congratulations! You have just purchased one of the most flexible subwoofers yet from KICKER. Your CompVR sub is designed to give you great bass perform­ance in a wide variety of applications. These installations instructions will help you get the most out of your new KICKER sub. Thanks for buying KICKER. Enjoy!
Installation Instructions
These enclosures combine KICKER’s CompVR woofer with computer designed and human-fine-tuned enclosures. They offer a level of bass per­formance never before thought possible from a commercially available enclosure. The HCVR Series enclosures are covered in carpet for protection and pre-loaded with a CompVR woofer.
KICKER HC enclosures are engineered to provide the best bass response
when mounted in the rear hatch or trunk.
Specifications
MModel
HHCVVRR1122
NOTE:
*The two ohm unit should be used with the KX Series Class D amplifiers KX550.3, KX700.5, KX400.1,
and KX600.1. It is not recommended for use with any KX two or four channel amplifiers.
The four ohm unit should be used with any KX Series two or four channel amplifier. It is not rec-
ommended for use with any KX Series Class D amplifiers.
Woofer Imp. Power Top Bottom Height Width
C12VR *2,4 400
Handling Depth Depth
(Watts) (In., cm) (In., cm) (In., cm) (In., cm)
1100
-13/16,27.5
1144
, 35.56
1155
, 38.10
1177
-3/16, 43.66
Mounting
After determining the best mounting position, check carefully in the areas where the mounting brackets will go. Make very sure that the mounting screws will not puncture the gas tank, brake lines, wire harnesses, etc., or interfere with any mechanical items on the underside of the chosen mount­ing surface. Turn the enclo­sure upside-down and attach the four mounting brackets to the bottom of the enclo­sure using the supplied small­er screws. Each bracket must be positioned so the rounded end protrudes approximately 3/4" from under the cabinet to allow a screw to easily pass through it for attachment to the vehicle.(See Diagram.)
Plug your subwoofer speaker wire into the termi­nals, using the red connector as positive and the black con­nector as negative. Hook the other end of this wire to your subwoofer amplifier in accordance with its owner's manual. This enclosure is wired internally to produce a 2 or 4 Ohm load at the terminals depending on the model.
With the enclosure right side up, securely attach it to the vehicle with the supplied larger screws. If the supplied hardware is not applicable to your installation, some other means of securely attaching the enclosure to the vehicle must be used.
To avoid potential injury from forward movement of the enclosure during abrupt stops or accidents, this enclosure must be properly installed and securely fastened to your vehicle.
2
Loading...
+ 2 hidden pages