Kicker HC12 Owner's Manual

HC12

REAR HATCH
or TRUNK

Move enclosure around and mount it
where it sounds best to you.

FRONT

Sealed Enclosure Systems

Congratulations! You have just purchased one of the most flexible subwoofers
yet from KICKER. Your Comp sub is designed to give you great bass performance
in a wide variety of applications. These installations instructions will help you get
the most out of your new KICKER sub. Thanks for buying KICKER. Enjoy!

Installation Instructions

These enclosures combine KICKER’s Comp woofer with computer
designed and human-fine-tuned enclosures. They offer a level of bass per­formance never before thought possible from a commercially available
enclosure. The HC Series enclosures are covered in carpet for protection and
pre-loaded with a Comp woofer.

KICKER HC enclosures are engineered to provide the best bass response

when mounted in the rear hatch or trunk.

MModel

HHC1122

Woofer Imp. Power Top Bottom Height Width

Comp 12 4 150

Specifications

Handling Depth Depth

(Watts) (In., cm) (In., cm) (In., cm) (In., cm)

1100

-13/16, 27.5

1144

, 35.56

1155

, 38.10

1177

-3/16, 43.66

Mounting

After determining the best mounting position, check carefully in the areas
where the mounting brackets will go. Make very sure that the mounting
screws will not puncture the gas tank, brake lines, wire harnesses, etc., or
interfere with any mechanical items on the underside of the chosen mount­ing surface. Turn the enclo­sure upside-down and attach
the four mounting brackets
to the bottom of the enclo­sure using the supplied small­er screws. Each bracket must
be positioned so the rounded
end protrudes approximately
3/4" from under the cabinet
to allow a screw to easily pass
through it for attachment to
the vehicle.(See Diagram.)

Plug your subwoofer
speaker wire into the termi­nals, using the red connector
as positive and the black con­nector as negative. Hook the
other end of this wire to your
subwoofer amplifier in accordance with its owner's manual.

With the enclosure right side up, securely attach it to the vehicle with the
supplied larger screws. If the supplied hardware is not applicable to your
installation, some other means of securely attaching the enclosure to the
vehicle must be used.

To avoid potential injury from forward movement of the enclosure
during abrupt stops or accidents, this enclosure must be properly
installed and securely fastened to your vehicle.

2