Kicker DE, SE Owner's Manual

DE & SE SERIES

SUBWOOFER ENCLOSURE SYSTEMS

INSTALLATION INSTRUCTIONS

After determining the mounting position, turn the enclosure upside-down and attach the four mounting brackets to the bottom of the enclosure using the enclosed small screws. Each bracket must be positioned so the rounded end protrudes approximately 3/4 inch from under the cabinet to allow a screw to easily pass through it for attachment to the vehicle.

Plug the speaker wires securely into the left and right speaker terminals. Make certain the polarity is the same on both sides. Failure to do this will result in the two channels being out of phase and will drastically reduce bass performance.

Position the enclosure in its mounting position and securely attach it to the vehicle with the enclosed large screws. If the brackets and screws are not applicable to your installation, some other means must be used to secure the enclosure to your vehicle.

IMPORTANT WARNING

To avoid potential injury from forward movement of the enclosure during abrupt stops or

accidents, this enclosure must be properly installed and securely fastened to your vehicle.

KICKER



HOW LONG WILL IT TAKE?

Stillwater Designs maintains a goal of 24-hour service for all returns. Delays may be incurred if

lack of replacement inventory or par ts is encountered.

INTERNATIONAL WARRANTY

Contact your International Stillwater Designs dealer or distributor concerning specific

procedures for your country’s warranty policies.

P.O. Box 459 • Stillwater, Oklahoma 74076 • U.S.A. • 405 624-8510

• Install slips (screwdriver holes)

• Damage caused by exposure to water and/or excessive heat.

• Damage through negligence, misuse, or accident.

• Items physically damaged due to abuse.

• Freight damage.

• The cost of shipping product to Stillwater Designs Service.

• Items previously repaired by any unauthorized repair facility.

• Items returned from unauthorized individuals or dealers.

• Return shipping on non-defective items.

• Speakers damaged due to amplifier clipping or distortion.

• Speakers with silicon caulk used for gasket material.

KICKER drivers are capable of producing sound levels that can permanently damage your hearing! Turning up a system to a level that has audible distor tion is more damaging to your ears than listening to an undistorted system at the same volume level. The threshold of pain is always an indicator that the sound level is too loud and may permanently damage your hearing.

Please use common sense when controlling volume!

WARNING:

MARCH 2000

SPEAKER SYSTEMS LIMITED WARRANTY

Stillwater Designs warrants this product to be free from defects in material and workmanship under

normal use for a period of one (1) year from date of original purchase, unless this product is labeled “B Stock”, in which case it is warranted for ninety (90) days from date of purchase. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction during the warranty period, Stillwater Designs will replace or repair (at its discretion) the defective merchandise with equivalent merchandise at no charge. Warranty replacements on “B-Stock” may have cosmetic scratches and blemishes. Discontinued products may be replaced with equivalent products.

This warranty is valid only for the original purchaser and is not extended to owners of the product sub-

sequent to the original purchaser. Any applicable implied warranties are limited in duration to a period of the express warranty as provided herein beginning with the date of the original purchase at retail, and no warranties, whether express or implied, shall apply to this product thereafter. Some states do not allow limitations on implied warranties, therefore these exclusions may not apply to you.

This warranty gives you specific legal rights; however you may have other rights that vary from state to

state.

WHAT TO DO IF YOU NEED WARRANTY OR SERVICE

Defective merchandise must be returned to your local Authorized Stillwater Designs (Kicker/Impulse) Dealer for warranty. Assistance in locating an Authorized Dealer can be obtained by writing or calling Stillwater Designs direct. You can confirm that a dealer is authorized by asking to see a current authorized dealer window decal.

If it becomes necessary for you to return defective merchandise, call the Kicker Customer Service Department at (405)624-8510 for a Return Authorization (RA) number. Package all defective items in the original container or in a package that will prevent shipping damage, and return to

Stillwater Designs, 5021 North Perkins Road, Stillwater, OK 74075

The RA number must be clearly marked on the outside of the package. Return only defective components. Return of entire cabinets, system packs, pairs, etc. increases your return freight charges. Nondefective items received will be returned freight collect.

Include a dated proof-of-purchase from an Authorized Dealer. Warranty expiration on items returned without proof-of-purchase will be determined from the manufacturing date code. Coverage may be invalidated if this date is greater than one (1) year previous to the date item is sent in. Freight must be prepaid; items received freight collect will be refused.

Failure to follow these steps may void your warranty. Any questions can be directed to the Kicker Customer Service Depar tment at (405)624-8510.

WHAT IS NOT COVERED?

This warranty is valid only if the product is used for the purpose for which it was designed.

It does not cover: