Kichler 41055 User Manual

SCREW

FRAME

RUBBER WASHER

NYLON WASHER

BUSHING

SUPPORT BRACKET

SUPPORT BRACKET

1) Align holes in support bracket with holes on
back of mirror.

2) Thread screw through hole in support bracket
and mirror.

3) Slip bushing over screw protruding from front
of mirror.

4) Slip nylon washer then rubber washer over
screw protruding from front of mirror.

5) Set frame on top of mirror aligning holes in
back of frame with screws.

6) Thread screws in to holes in frame. Tighten
screws to secure frame in place.

7) Note position of support bracket inside back of
mirror.

8) Determine desired location of mirror on wall.

9) At position where support bracket will be, mark
position of top holes using the wall bracket as
a template.

10) Drill 3/8” (10mm) diameter holes in wall at marks.

11) Slip mounting screws through holes in wall
bracket and thread wings on to screws.

12) Compress wings and slip through holes drilled
in wall.

13) Tighten screws until wall bracket is secure
against wall.

14) Slip fixture over wall bracket until support
bracket lays in “J” of wall bracket.

WING

MOUNTING SCREW

WOOD SCREW

WALL BRACKET

Date Issued: 2/8/13 IS-41055-BL