Page 1
Kichler® Lighting
7711 East Pleasant Valley Road
P.O. Box 318010
Cleveland, Ohio 44131-8010
Customer Service
866.558.5706
8:30 AM to 5:00 PM EST,
Monday - Friday
TM
Golden Iridescence
A Kichler® Décor™ ceiling fan
Designed to coordinate with a popular Kichler Lighting collection.
Instruction Manual
Page 2
1
"CAUTION-RISK OF FIRE"
CONSULT A QUALIFIED ELECTRICIAN TO
ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.
Nut
Lock washer
Switch housing
cover
1. SAFETY RULES
WARNING! RISK OF ELECTRIC SHOCK
All electrical connections must be in accordance
with local codes, ordinances, or national codes. If
you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified
electrician.Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse block. Turning power off
using fan switch (speed control on/off) is not sufficient to prevent electrical shock.
NOTE: The important safeguards and instructions
appearing in this manual are not meant to cover all
possible conditions and situations that may occur.
It must be understood that common sense, caution and care are factors which cannot be built into
any product. These factors must be supplied by
the person (s) caring for and operating the unit.
2.
INSTALLING THE LIGHT KIT
1. Take the fixture out of the box and packing
foam. Remove the Switch Housing cover from
your Ceiling Fan. Remove the decorative plate,
decorative ball and finial from it. Thread the Light
Fixture into the hole in the center of the Switch
Housing cover. On the inside of the Switch Housing cover, add a lock washer and nut to the Light
Fixture and tighten. (Fig. 1)
Mounting plate
AMP connector
Light kit
Fig. 1
Fig. 2
Light kit
Switch housing cover
Plastic nut
Black wire
Black wire
White wire
White wire
Note: All screws must be checked and retightened where necessary.
2. You can find total 4 pcs plastic nuts preinstalled
on the end of the black and white wires coming
from the switch housing cover and light fixture.
Remove the plastic nuts first, and twist the bare
section of same color wires into one body, then
place the plastic nut on it. Finally match up the
color on the side of the connector and push them
together until the snap engages. (Fig. 2)
Page 3
3. Carefully push all of the wires into the Switch
Housing. Align the keyholes on the light fixture
with the screws on the mounting plate. Turn the
light fixture counterclockwise and tighten all
three screws. (Fig 3)
Golden Iridescence
Screw
Light kit
Fig.
TM
2
2. INSTALLING THE LIGHT BULBS &
GLASS SHADE
1. Install 3 x 60W bulbs (not included) .
(Fig 4)
2. Place glass shade over the light kit stem,
secure with the metal nut(rubber side on the top),
decorative plate, decorative ball and finial. (Fig 4)
3. Restore power only after installation is
completed.
Bulb
Manual nut
Silicon washer
Finial
Metal washer
Decorative ball
Fig.
Loading...