Page 1
Page 2
1
1. SAFETY RULES
"CAUTION-RISK OF FIRE"
CONSULT A QUALIFIED ELECTRICIAN TO
ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.
WARNING! RISK OF ELECTRIC SHOCK
All electrical connections must be made in
accordance with local codes, ordinances, or
national codes. If you are unfamiliar with
installing electrical wiring, secure the services
of a qualified electrician. Before starting this
installation, disconnect the power by turning off
the circuit breaker at your main panel or
removing the fuse at the fuse block. Turning
the power off using the ceiling fan switch
(speed control on/off) is not sufficient to
prevent electrical shock.
NOTE: The important safeguards and
instructions appearing in this manual are not
meant to cover all possible conditions and
situations that may occur. It must be
understood that common sense, caution and
care are factors which cannot be built into any
product. These factors must be supplied by the
person (s) caring for and operating the unit.
Lock washer
Switch
housing
Center
plug
Nut
Fig. 1
Light kit
2.
INSTALLING THE LIGHT KIT
1. Remove and discard the center plug from
the switch housing. Attach the light kit to the
switch housing by feeding the light kit wires
(black and white) through the hole of switch
housing and then screw it onto the switch
housing by nut & lock washer. Be sure it is
tight enough to prevent light kit from vibrating
loose. (Fig. 1)
2. Locate two single white and blue wires in
the switch housing labeled FOR LIGHT.
3. Make the polarized plug connections:
- White to white
- Blue to black
Page 3
Sterling Manor
4. Raise and hold the light kit assembly close
to the mounting plate. snap together the wire
connection plugs. (Fig. 2)
5. Carefully push all wires back into the
switch housing, then install the light kit
assembly onto the mounting plate with 3
screws provided. Be sure to tighten all
screws. (Fig. 2)
TM
3 Light Fixture
Mounting plate
Wire connector
2
3. INSTALLING THE GLASS SHADES &
LIGHT BULBS
1. Mount the glass shades to the light fixture
by unscrewing partway the thumbscrews on
the glass holders, inserting the glass, then
gently tightening the thumbscrews by hand
evenly to the glass. DO NOT OVER
TIGHTEN. (Fig. 3)
2. Install 3, 60 watt candelabra bulbs (not
included). (Fig. 3)
3. Restore power only after installation is
completed.
Light kit
assembly
Light kit
Screws
assembly
Fig. 2
Screws
Glass
shade
Bulbs
Fig. 3
Loading...