Kichler 337011 User Manual

1

337011

LIGHT WALL CONTROL
INSTALLATION INSTRUCTIONS

WARNING

To avoid fire, shock and serious personal injury, follow these instructions:

1. Carefully read and retain this Instruction Manual for future reference.

2. To avoid possible electrical shock, be sure the electricity is turned off at
the main panel by removing the fuse or opening the circuit breaker.

3. This control switch is designed for use with "Ceiling Fans" ONLY. DO
NOT use with any other type of electrical appliance.

4. All wiring must conform to national and local electrical codes. If you feel
you do not have enough electrical knowledge, have a licensed electrician
install the control.

5. The total wattage for the lights 300W.

Outlet box

Black wire to Black
Household supply
wire in the ceiling
outlet box.

Switch

Wall plate

Fig. 1

Green ground ( )lead

INSTALLATION AND OPERATING
INSTRUCTIONS

1. Disconnect the power and remove the existing wall plate and switch. (Fig. 1)

2. Push the slide switch all the way down to the OFF position. (Fig.2)

3. Make each of the wire connections illustrated in Figure 3. Secure each

with the wire nuts provided.
Connect the Black wire from the switch to the Black Household Supply
Wire (AC in L)
Connect the Green (ground) wire from the Switch to the Household
ground wire.
Connect the Black wire from the Switch to the Black wire leading to the

Blue wire on the Fan. This is the wire that controls the ceiling fan light

fixture. DO NOT connect this switch to the ceiling fan motor.

4. If your outlet box has a ground wire (green or bare copper) connect the
wall transmitter's ground wire to it; otherwise connect the wall transmitter's
ground wire directly to one of the screws from the outlet box.

Black (AC IN L)
to hot household

Fig. 2

SUPPLY CIRCUIT

BLACK

BLACK

Fan

Black (AC in L)

GREEN

WHITE WHITE

BLACK

BLUE

Ground Conductor

Outlet Box

Green Ground Lead

Ground to Downrod

Fig. 3

2

Screws

Wall plate

Screws

Switch

Fig. 4

Outlet box

5. Attach the Light Dimmer Switch to the wall outlet box and secure with
the two screws provided. (Fig 4)

6. Attach the wall plate to the switch with the two screws provided. (Fig. 4)

NOTE: The On/Off switch (pull chain) on the ceiling fan light
fixture must be set to ON.

OPERATING YOUR WALL CONTROL

Light Slide Switch: This Slider turns the light fixture On or
OFF and adjust the Brightness of the fixture. OFF is all the way
down.

Fig. 5

TROUBLESHOOTING GUIDE

If the switch does not work correctly, check the following.

● Check the main power supply and make sure the circuit is

powered ON.

● Make sure the Light Fixture pull chain is set in the ON position.