Kichler 337010 User Manual
1
DUAL SLIDE WALL CONTROL
337010
INSTALLATION INSTRUCTIONS
WARNING
To avoid fire, shock and serious personal injury, follow these instructions:
1. Carefully read and retain this Instruction Manual for future reference.
2. To avoid possible electrical shock, be sure the electricity is turned off at
the main panel by removing the fuse or opening the circuit breaker.
3. This control switch is designed for use with "Ceiling Fans" ONLY. DO
NOT use with any other type of electrical appliance.
4. All wiring must conform to national and local electrical codes. If you feel
you do not have enough electrical knowledge, have a licensed electrician
install the control.
5. The amperage for your fan should not exceed 1.25A. The total wattage
for the lights 300W.
Outlet box
Black (to motor)
speed control lead
Switch
Fig. 1
Black/white (AC IN L)
to hot household
Blue (for light)
light switch lead
Green ground ( ) lead
Wall plate
Speed
switch
Light
switch
INST ALLA TION AND OPERA TING
INSTRUCTIONS
1. Disconnect the power and remove the existing wall plate and switch. (Fig. 1)
2. Push BOTH slide switches all the way down to the OFF position. (Fig.2)
3. Make each of the wire connections illustrated in Figure 3. Secure each
with the wire nuts provided.
Black wire going to the fan (motor) to the Black wire from the Switch.
In the Ceiling Outlet Box, connect the White (neutral) wire coming from
the Fan to the White (neutral) wire from the Household Supply.
Connect the Blue (For Light) wire coming from the fan to the Blue (For
Light) wire from the Switch.
Connect the Black & White (AC IN L) from the switch to the Black wire
going to the Household Supply.
4. If your ceiling outlet box has a ground wire (green or bare copper) connect
it to the ground wire from the ceiling fan and/or the ceiling mounting
bracket.
Fig. 2
SUPPLY CIRCUIT
BLACK/
WHITE
BLACK
BLUE
Fan
BLACK
BLACK
BLUE
Fig. 3
GREEN
WHITE WHITE
Ground Conductor
Outlet Box
Green Ground Lead
Ground to Downrod
2
Screws
Wall plate
Screws
Switch
Fig. 4
Outlet box
5. Attach the Speed/Light Switch to the wall outlet box and secure with the
two screws provided. (Fig 4)
6. Attach the wall plate to the switch with the two screws provided. (Fig. 4)
NOTE: If your fan has the original pull chain speed control, you
MUST set and leave this control on High Speed. The On/Off switch
(pull chain) on the ceiling fan light fixture must be set to ON.
OPERATING YOUR WALL CONTROL
Restore power to the ceiling fan and test for proper operation.
Speed Slide Switch: The Slider is used to set each fan speed
separately. Move it up or down to select the desired speed.
1= High Speed
2 = Medium High Speed
3 = Medium Speed
4 = Low Speed
= Fan Off
Fig. 5
Light Slide Switch: This Slider turns the light fixture On or OFF
and adjust the Brightness of the fixture. OFF is all the way down.
TROUBLESHOOTING GUIDE
If either slide switch does not work correctly, check the following.
● Check the main power supply and make sure the circuit is
powered ON.
● Make sure the Manual Speed Pull Chain is set on HIGH SPEED.
● Make sure the Light Fixture pull chain is set in the ON position.
Loading...