Kichler 337008 User Manual

1

BE SURE TO FOLLOW ALL STEPS IN THE
ORDER GIVEN. BE SURE POWER IS OFF
AT FUSE, OR CIRCUIT BREAKER BOX.

A

B

A. Canopy
B. Mounting plate (located inside canopy)
C. #10 X 1.5" Wood screws (2 PCs.),

C

D

#8-32 X 3/4" Machine screws (2PCs.),
4mm Star washers (2 PCs.),

E

Wire nuts (3 PCs. ), Washers (2PCs.).
D. 3/16" x 16 mm screws (3PCs.), Rubber

Ceiling
mounting
plate

gasket.
E. Safety cable hardware: Wood screw, Lock

Fig. A

Screws

Ceiling
canopy

Canopy
ring

washer and Flat washer.

1. Remove the canopy ring from the canopy.
(Fig. A)

2. Remove the mounting plate from the canopy
by loosening the four screws on the top of the

Screws
3/16" X 16 MM

canopy. Remove the two non-slotted screws
and loosen the slotted screws. This will enable

Canopy

you to remove the mounting plate. (Fig. A)

Fig. B

Fig. C

Rubber gasket

Canopy ring

Motor
housing

Outlet box

Mounting plate

Star Washers
Flat Washers

Screws
8-32 X 3/4"

3. Remove 3 of the 6 screws (Every other
screw) from the top of the motor housing.

4. Route motor wires through the canopy ring,
rubber gasket and canopy supplied with this kit.
(Fig. B)

5. Align the recessed holes in the canopy along
with the rubber gasket over the three screw
heads on the top of the motor housing. (Fig. B)

6. Secure the canopy to the top of the motor
housing by tightening three 3/16" x 16mm
screws provided. (Fig. B)

7. Secure the mounting plate to the ceiling
outlet box using the two 8-32 x 3/4" screws, star
washers, lock washers and flat washers
provided. (Fig. C)

8. Hang the fan on the hook of the mounting plate,
refer to the instruction manual included with your
fan for the wire connections. An additional safety
support is provided to prevent the fan from falling
fan). Place the endof cable through the loop of
ceiling support cable. Pull as much cable through
loop as possible. Feed end of cable into clamp
hole and fi rmly tighten screw. Cut off excess
safety cable. Secure the safety cable to the ceiling
joist with screw and washer. (Fig. D)

9. Secure the ceiling fan canopy to the mounting
plate with the four 3/16" x 3/8" screws and lock
washers provided. (Fig. E) Raise canopy ring up
against canopy and secure it to canopy until snug.

Ceiling Adapter Kit

Wood screw

Attach safety cable
to ceiling joist with
screw and washer

2

Fig. D

Mating holes

Screws

Canopy ring

Fig. E