Page 1
KICHLER® LED DESIGN PRO BRIGHT DISC™
EXTENSION WIRE
INSTALLATION INSTRUCTIONS
P/N: 12347BK, 12347WH
Before Installing:
All installations should comply with National and local electrical
codes. If you have any doubts concerning installation contact a
qualified, licensed electrician.
This system is intended to be installed with a Kichler® Class 2
24VDC power supply.
NOTE: Read all instructions thoroughly before starting installation.
PLEASE SAVE THESE INSTRUCTIONS
1. Turn off power before modifying/installing the system.
2. This wire can only be used with Kichler® LED Bright Disc™
(P/N 12310) and Kichler® Driver Module (P/N 12354)
3. Hold extension wire to mounting surface and determine
best path for cable. If extension wire is being run from
cabinet to cabinet a notch such as a “V” could be cut in
cabinet side panels to help keep cable out of sight. (See
Fig. 3)
4. If mounting Kichler® LED Bright Disc™ above cabinet and
Kichler® Driver Module under cabinet, drill 5/16” hole in top
and bottom cabinet surface and thread male ends of
connector through holes.
5. Plug each connector of the extension into their associated
connectors on the Kichler® LED Bright Disc™ (P/N 12310)
or Kichler® Driver Module (P/N 12354). The connectors
will click when fully seated.
6. Peel backing off of female end connector and affix to desired
location. Surface should be as clean as possible. Drive pre-
installed screw into the cabinet surface to secure the connector
to the surface. (See Fig. 4)
NOTE: DO NOT OVER TIGHTEN SCREWS.
7. Peel backing off retaining clip(s) and affix to desired
location(s). Surface should be as clean as possible. Drive pre installed screw into the cabinet surface to secure the retaining
clip to the surface.
NOTE: DO NOT OVER TIGHTEN SCREWS.
8. Slip wire into clip(s) and snap closed.
EXTENSION WIRE
MOUNTING PUCK ON TOP
OF CABINET
5/16" HOLE
EXTENSION WIRE ACCESSORY
BACKING
CABINET SIDE
PANEL
PRE-INSTALLED SCREW
Fig. 3
Date Issued: 8/22/08 IS-12347-US
Fig. 4
Loading...