Kichler 10579 User Manual

FIXTURE HOUSING

CHANNEL

PLASTIC FACE

(THIS END FIRST)

PLASTIC FACE

CHANNEL

FIXTURE

HOUSING

1) Determine desired location for mounting fixture. When
doing this keep in mind distance from fixture to receptacle and
that mounting surface should be a minimum of 1/2” thick..

2) Hold fixture housing in desired mounting position and mark
position of keyholes. Put fixture housing down and start
screw at marks.

3) Slip large portion of keyhole over screwheads and push fixture
to one side. This will allow both hands freedom for tightening
screws.

4) Insert recommended bulbs, if removed.

6) Plastic face of diffuser has a slight lip.
Insert lip into channel at front of fixture
housing.

7) Swing diffuser up towards fixture housing
until diffuser snaps into place.

8) Plug fixture into receptacle.

9) To remove diffuser: Place thumbs on diffuser face and finger
tips on lip between diffuser face and diffuser glass. Apply
slight pressure to diffuser face with thumbs and pull fingers
toward thumbs.

IS-10579-BL