Page 1
SAFETY INSTRUCTIONS
READ THIS FIRST
KEEP THESE INSTRUCTIONS
This fixture is intended for installation in accordance with the National Electric Code (NEC) and local code specifications.
Failure to adhere to these codes and instructions may result in serious injury and/or property damage and will void the warranty.
If you have any doubts concerning installation, contact a qualified licensed electrician.
2.
WIRING MODULE FOR USE ONLY
4.
WITH KICHLER® CABINET LIGHTING
1. TURN OFF POWER.
2. On one side of wire module there are two gates. Feed
through gate approximately 5 inches of Type NM
non-metallic sheathed cable 12-2 with ground, or 14-2
with ground only. NOTE: These gates serve as strain
3.
6.
7.
11.
reliefs holding cable securely in place. Gates should not
be removed and no more then one cable should go
through each.
3. Peel back jacket on cable to within one inch of inside of
gate.
4. Strip approximately 1/2 inch of insulation off each black
and white wire. NOTE: On inside of wire module cover is
a gauge to assist in stripping the correct amount of
insulation.
5. Pushed stripped wires into the appropriate connector:.
black to black
white to white
bare wire to green
Slightly tug on each wire to insure connection has been
made and is secure.
6. Push wire module to mounting surface of cabinet (as
close to wall as possible) allowing excess cable to feed
back into wall. Secure wire module in place using
provided screws. It may be necessary to drill 1/16”
maximum pilot holes.
7. Push wires and connectors inside wire module. We
suggest pushing each connector towards a different
corner of wire module.
5.
BLACK/BLACK
BARE WIRE/GREEN
8.
WHITE/WHITE
Date Issued: 8/29/08
8. Slip legs on wire module cover into slots inside wire
module and until cover snaps in place.
9. Snap connector cover(s) over connector(s) not being used.
10. At this time proceed to fixture installation following
instructions provided with fixture.
11. To remove cover, slide screwdriver into slot formed by
cover and wire module then pull screwdriver handle away
from wire module until cover separates from wire module.
9.
IS-10570-BL
Loading...