Kichler 10567 User Manual

gauge

black/black

bare wire/green

white/white

5.

IS-10566-US

7.

4.

connectors

1. Turn off power.

NOTE: All installations should comply with local

electrical codes. If you have any doubts concerning

installation contact a qualifi ed licensed electrician.

2. On one side of wire module there are two gates.

Feed approximately 5 inches of Type NM non-

metal sheathed cable (12 gauge maximum)

through gate.

NOTE: These gates serve as strain reliefs

holding cable securely in place. Gates should not

be removed and no more then one cable should

go through each.

3. Peel back jacket on cable to within one inch of

inside of gate.

gate

2.

3.

4. Strip approximately 1/2 inch of insulation off each

black and white wire.

NOTE: On inside of wire module cover is a gauge

to assist in stripping the correct amount of

insulation.

5. Push stripped wires into the appropriate connector:

black to black

white to white

bare wire to green

Slightly tug on each wire to insure connection has

been made and is secure.

6. Push wire module to mounting surface of cabinet

(as close to wall as possible) allowing excess

cable to feed back into wall. Secure wire module

slot

cable

in place using provided screws. It may be necessary

to drill 1/16” maximum pilot holes.

7. Push wires and connectors inside wire module.

We suggest pushing each connector towards a

different corner of wire module.

8. Slip legs on wire module cover into slots inside

wire module and until cover snaps in place.

NOTE: To remove cover, slide screwdriver into

slot formed by cover and wire module then pull

screwdriver handle away from wire module until

cover separates from wire module.

8.

wire module cover

slot

6.

Opening Diffuser:

• Turn off fi xture and allow to cool.

• Place fi nger tip on tab of each diffuser end cap.

• LIft and slide diffuser at tabs.

• Lower that edge of diffuser

Closing Diffuser:

A. Swing edge of diffuser with tabs up toward fi xture until

pegs by tabs slip into slots in middle of fi xture end caps.

B. Slide tabs forward allowing pegs to seat in slots.

A.

B.

mounting surface

bulb compartment

connector cover

wire module

backing

10.

9. Determine desired location for mounting

fi xture. Mounting surface should be a

minimum of 1/2” thick and approximately

2 1/2” clearance for interconnect cable

should be allowed at both ends of fi xture.

10. Position fi xture against mounting surface

with bulb compartment towards back.

11. Drive pre-installed screws into mounting

surface until fi xture is secure. If screws are

diffi cult to install, remove screws and bushings,

mark holes, and drill 1/16” maximum pilot

holes.

12. Connect fi xture to wire module using

12.

11. 14. 16.

interconnect cable

interconnect cable.

13. Hold interconnect cable to mounting surface

and determine best path for cable.

NOTE: Interconnect cable is not intended for

use through or concealed behind walls, fl oors

or ceilings.

14. Peel backing off retaining clip(s) and affi x

to desired location(s). Surface should be

as clean as possible.

15. Slip cable into clip(s) and snap closed.

16. If no other fi xtures will be added at this time

use connector cover over connectors not

being used.

17. Maximum number of lamps per run cannot

exceed 30 lamps.

page 2 IS-10566-US