8751A-17
SUPERSEDES: None
Continued
DATE: 15 April 1995
8751A Network Analyzer
Serial Numbers: 0000J00000 / 3146J00696
0000A00000/3146A00212
Duplicate Service Notes: None
Modification to fix unexptected spurious problem.
To Be Performed By: Agilent-Qualified Personnel
Parts Required:
1 of 3
AUTHOR: MT
ENTITY: 3355
© 1993 AGILENT TECHNOLOGIES
PRINTED IN U.S.A.
SERVICE NOTE
ADMINISTRATIVE INFORMATION
MODIFICATION RECOMMENDED
SERVICE NOTE CLASSIFICATION:
ACTION
CATEGORY:
LOCATION
CATEGORY:
CUSTOMER INSTALLABLE
ON-SITE
SERVICE CENTER
RESPONSIBILE UNTIL: 15 April 1995
ADDITIONAL INFORMATION:
IMMEDIATELY
ON SPECIFIED FAILURE
AGREEABLE TIME
AVAILABILITY:
PRODUCT’S SUPPORT LIFE
RETURN
SCRAP
SEE TEXT
SERVICE
INVENTORY:
RETURN
SCRAP
SEE TEXT
USED
PARTS:
STANDARDS:
Labor 2.0 hrs
Part No. Qty Description
1901-0050 1 Diode
0757-0280 1 Resistor 1K
0698-3444 1 Resistor 316
9100-3548 1 Inductor 470 NH
1854-1073 1 Transistor
0160-4832 1 Capacitor 0.01 UF
0698-3441 1 Resistor 215
Page 2 Service Note 8751A-17
Situation:
The 8751A may show the unexpected spurious response due to the parasitic oscillation
of the source signal.
Solution:
This is caused by the breakdown of A3Q2 transistor. This symptom can be confirmed
using the following procedures:
1. Set the 8751A as follows:
CENTER --> 500 MHz
SPAN --> 0 Hz
2. Connect the Spectrum Analyzer to the 8751A’s “RF OUT”, and observe the signal
with 1 MHz frequency span.
3. Connect the Signal Generator to “EXT REF IN” on the rear panel. Set the Signal
Generator to 10 MHz.
4. Change the frequency of Signal Generator from 9.9998 MHz to 10.0002 MHz.
Observer the 8751A’s ouput signal using the Spectrum Analzyer. If a spurious is
observed, the A3Q2 transistor is broken.
Action:
Modify the A3 board with referring the following procedures:
1. Turn the 8751A off. Remove the top cover and the shield plate.
2. Remove the A3 board.
3. Modify the A3 board with referring Figure 1:
a. Replace the A3Q2 transistor (P/N 1854-1073) with the new one.
b. Replace the R3 resistor. 464 ohm --> 1 kohm (P/N 0757-0280)
c. Replace the R6 resistor. 464 ohm --> 316 ohm (P/N 0698-3444)
d. Replace the L2 inductor. 680 nH --> 470 nH (P/N 9100-3548)
e. Replace the location of C5 (0.01 uF, P/N 0160-4832) and R19 (215 ohm, P/N
0698-3441).
f. Add the diode (P/N 1901-0050) with referring Figure 1.
4. Perform the following adjustments:
100 MHz VCXO Frequency
Fractional N Osc Spurious
1st IF Offset Osc Frequency
LF power linearity
5. Reinstall the A3 board.
Loading...