0
I
OPERATING INFORMATION
86633B
MODULATION
SECTION
AM-FM
Printed: DECEMBER 1975
0 Hewlett-Packard Co. 1975
COPYRIGHT AND DISCLAIMER NOTICE
Copyright - Agilent Technologies, Inc. Reproduced with the permission of Agilent
Technologies Inc. Agilent Technologies, Inc. makes no warranty of any kind with regard
to this material including, but not limited to, the implied warranties of merchantability
and fitness for a particular purpose. Agilent Technologies, Inc. is not liable for errors
contained herein or for incidental or consequential damages in connection with the
furnishing, performance, or use of this material or data.
Model 86633B General Information
SECTION I
GENERAL INFORMATION
l-l. INTRODUCTION
1-2. This manual contains all information required
to install, operate, test, adjust, and service the HP
Model 86633B Modulation Section plug-in.
l-3. The various sections of this manual provide
information as follows:
a. SECTION I, GENERAL INFORMATION,
such as description, specifications, accessories, and
recommended test equipment.
b. SECTION II, INSTALLATION, provides
information relative to incoming inspection, preparation for use, mounting, packing and shipping.
C.
SECTION III, OPERATION, provides
information relative to operating the instrument.
d. SECTION IV, PERFORMANCE TESTS,
provides information required to ascertain that the
instrument is performing in accordance with
published specifications.
e.
SECTION V, ADJUSTMENTS, provides
information required to properly adjust and align
the instrument after repairs.
f. SECTION VI, REPLACEABLE PARTS,
provides ordering information for all parts and
assemblies.
l-6. On the title page of this manual, below the
manual part number, is a “Microfiche” part number. This number may be used to order 4 x 6-inch
microfilm transparencies of the manual. Each
microfiche contains up to 60 photo-duplicates of
the manual pages. The microfiche package also
includes the latest Manual Changes supplement as
well as all pertinent Service Notes.
1-7. SPECIFICATIONS
l-8. Instrument specifications are listed in Table
l-l. These specifications are the performance standards, or limits against which the instrument may be
tested.
l-9. INSTRUMENTS COVERED BY MANUAL
l-10. This instrument has a two-part serial num-
ber. The first four digits and the letter comprise
the serial number prefix. The last five digits form
the sequential suffix that is unique to each instrument. The contents of this manual apply directly
to instruments having the same serial number
prefix as listed under SERIAL NUMBERS on the
title page.
l-11. For information concerning a serial number
prefix not listed on the title page or in the Manual
Changes supplement, contact your nearest Hewlett-
Packard office.
SECTION VII, MANUAL CHANGES, is
g.
reserved to provide backdating and for modification information in late editions of this manual.
h. SECTION VIII, SERVICE, includes infor-
mation required to service the instrument.
1-4. Figure 1-l shows the Modulation Section.
l-5. Packaged with this manual is an Operating
Information Supplement. This is simply a copy of
the first three sections of this manual. This supple-
ment should stay with the instrument for use by
the operator. Additional copies of the Operating
Information
separately through your nearest Hewlett-Packard
office. The part number is listed on the title page
of this manual.
Supplement may be ordered
l-12. MANUAL CHANGE SUPPLEMENT
l-13. An instrument manufactured after the print-
ing of this manual may have a serial prefix that is
not listed on the title page. This unlisted serial
prefix indicates that the instrument is different
from those documented in this manual. The
manual for this instrument is supplied with a
yellow Manual Changes supplement that contains
“change information” that documents the differ-
ences.
l-14. In addition to change information, the
supplement may contain information for correcting errors in the manual. To keep this manual
as current and accurate as possible, HewlettPackard recommends that you periodically request
l-l
Loading...