8514B S-Parameter Test Set,
0.045GHz to 20GHz, 3.5 mm
Data Sheet
Frequency Range: 0.045 to 20 GHz
Test Ports (port 1 or 2)
Nominal Operating Power Level:
2 to -6 dBm
Connector Type: 3.5 mm, male
Impedance, DC Bias: 50 ohm nominal, 500 mA, 40 Vdc maximum
Attenuation Range (incident signal)
0 to 90 dB, in 10 dB steps
RF Input Connector (rear panel)
Maximum Input Power: +16 dBm
Connector Type: 3.5 mm, female
Dynamic Ra nge (for transmission measurements)
Frequency Range (GHz)
.045 to 2 2 to 8 8 to 20
Maximum Power (dB m)
Measured at Port 2: +20 +11 +10
Reference Power (dBm)
at Port 1 (nominal): +2 -2 -6
Minimum Power (dBm)
Measured at Port 2: -66 -95 -95
Receiver
Dynamic Ra nge (dB): 86 106 105
System
Dynamic Ra nge (dB): 68 93 89
Measurement Port Characteristics
Frequency Range (GHz)
.045 to 2 2 to 8 8 to 20
Residual (dB)
Directivity: 48 44 44
Source Match: 40 33 31
Load Match: 48 44 44
Reflection Tracking: ±0.003 ±0.003 ±0.006
Transmission Tracking: ±0.017 ±0.044 ±0.084
Crosstalk: 89 115 110
Raw (typical) (dB) (before calibration/error correction)
Directivity: 23 23 14
Source Match: 17 15 11
Load Match: 17 15 11
Loading...