53
Programmable and Manual Step
Attenuator/Switch Driver
Attenuator Accessories
HP Model HP Part
Number Number Where Used Description
11764A 11713A to 84904/906/907 10-pin DIP to Viking conn., 60 inches
11764B 84904/906/907 to ribbon 10-pin DIP to 60 inch ribbon cable, bare leads
11764C 84904/906/907 to DIP 10-pin DIP to 14-pin DIP, 8-inch ribbon cable
11764D 84904/906/907 to DIP 10-pin DIP to 14-pin DIP, 16-inch ribbon cable
11764-60005 84941A dist bd to 8494/95/96/97 Viking to (4) 4-pin Berg conn., 30 inches
11764-60006 84941A dist bd to 84904/906/907 10-pin DIP to (4) 4-pin Berg conn., 30 inches
70612-60017 84941A dist bd to 8494/95/96/97 Viking to (4) 4-pin Berg conn., 20 inches
70612-60018 84941A dist bd to 84904/906/907 10-pin DIP to (4) 4-pin Berg conn., 20 inches
Attenuator Cables
For complete cable configuration information, request publication number 5963-2038E,
HP 70611A, HP 87130A and
HP 11713A Switch Attenuator Driver Configuration Guide
.
Attenuator Accessories
HP 11716 Series Attenuator Interconnect Kits
These kits can be utilized to connect any two of
the HP 8494/95/96 attenuators in series. The rigid
interconnect cable is available in type-N, APC-7,
and SMA connectors as described below.
HP 11716A Attenuator Interconnect Kit (type-N)
HP 11716B Attenuator Interconnect Kit (APC-7)
HP 11716C Attenuator Interconnect Kit (SMA)
HP 11717A Attenuator/Switch Rack Mount
Support Kit
This kit provides the necessary hardware to mount
programmable attenuators and switches inside a test
system rack mount cabinet.
HP 11713A
HP 11716A
6
Attenuators
Visit our web site http://www.hp.com/go/mta
HP 11713A Attenuator/Switch Driver
This driver provides HP-IB or “local” front panel drive
control for programmable attenuators and electromechanical switches. Concurrently drive up to two
HP 8494/95/96 and HP 87904/906/907 programmable
attenuators and two electromechanical switches
(HP 8761, 8762 or 8765 series). The HP 11713A can
also be used to supply +24V common and ten pairs of
current sinking contacts (total current draw <1.25A
peak for 1 sec., 0.65A steady state) to independently
control up to 10 relays. An integral power supply (with
short circuit protection) eliminates the need for an
external power source. Each HP 11713A is supplied
with two plug-in drive cables to simplify connection
to programmable attenuators. Switching time is less
than 10 milliseconds.
Loading...