Keys Fitness HT440EL User Manual

Owner’s Manual

Health Trainer 440 Elliptical

Customer Service

1.888.340.0482

Keys Fitness

4009 Distribution Drive
Suite 250
Garland, TX 75041

www.keysfitness.com

315-00104
Rev A 06/07

Model Name : HT440EL

Serial Number :

Write down for future reference

Serial Number Decal Location

Table of Contents

Important Safety Information 3

Before You Start 4

Assembly 5-10

Console Overview 11-13

Monitoring Your Heart Rate 14-15

Moving Instructions 16

Warm Up Exercises 17

Exploded View 18

Parts List 19

Warranty 20

2

Important Safety Information

WARNING! Before using this unit or starting any exercise program, consult your physician.

This is especially important for persons over the age of 35 and/or persons with pre-existing
health problems. The manufacturer or distributor assumes no responsibility for personal injury
or property damage sustained by or through the use of this product.

SAFETY PRECAUTIONS AND TIPS

1. It is the owner's responsibility to ensure that all users of this unit have read the Owner's
Manual and are familiar with warnings and safety precautions.

2. This unit has a user maximum capacity of 250 pounds.

3. The unit should only be used on a level surface and is intended for indoor use only. The unit
should not be placed in a garage, patio, or near water and should never be used while you are
wet. Keys Fitness recommends a mat be placed under the unit to protect floor or carpet and for
easier cleaning.

4. Wear comfortable, good-quality walking or running shoes and appropriate clothing. Do not
use the unit with bare feet, sandals, socks or stockings.

5. Always examine your unit before using to ensure all parts are in working order.

6. Allow the unit to fully stop before dismounting.

7. Pets should never be allowed near the unit.

8. Do not leave children unsupervised near or on the unit.

9. Never operate the unit where oxygen is being administered, or where aerosol products are
being used.

10. Never insert any object or body parts into any opening.

11. For safety and to prevent damage to your unit, no more than one person should use the
unit at a time.

12. Service to your unit should only be performed by an authorized service representative,
unless authorized and/or instructed by the manufacturer.

13. Failure to follow these instructions will void the unit warranty.

3

Before You Start

Thank you for purchasing the Health Trainer HT440EL Elliptical! This quality product you
have chosen was designed to meet your needs for cardiovascular exercise. Before you start,
please read the Owner's Manual and become familiar with the operation of your new unit.

Remember to take the time to perform the stretching exercises provided to avoid
injury.

If you are taking medication, consult your physician to see if the medication will affect your exer­cise heart rate.

If you have heart problems, you are not active, and/or are over the age of 35 years, do not use
the pre-set programs or start an exercise program without first contacting and receiving approval
from your physician.

To avoid the risk of electrical shock, always keep the console dry. Do not spill liquids on the con­sole. Keys Fitness recommends a sealed water bottle for beverages consumed while using the
unit.

Please review the following drawing below to familiarize yourself with the listed
parts.

Console

Transport Wheels

Pulse Handlebar

Pedals

Front Stabilizer

4

Assembly

19

10x13x14x15x17x19 Screw Driver

M5 Allen Wrench

14

13

10

15

8X19 Arc Washer(34)-8

10*26*2.0 Washer(48)-4

6*13*1.0 Washer(63)-4

M8x15 Screw (65)-4

M6 cap nut(64)-4

M6X40mm Carriage Bolt(62)-4

3/8" Nylon Locknut(49)-4

M8X70mm Carriage Bolt(35)-4

3/8" Nylon Locknut(47)-4

M8 Cap Nut(33)-4

M5 Allen Wrench

INSTRUCTIONS FOR ASSEMBLY:

Unpack the box in a clear area. Check to make sure all components are present and in good
condition. Do not dispose of the packing material until the assembly is completed. Tools have
been provided for you to use when assembling this product.

Locate the hardware pack and identify the following parts required for assembly.

5

Assembly

9

7

4 6

8

5

1

3

2

Assembly Part Identier

6

Assembly

2

34

33

33

34

35

54

33

34

35

1

34

33

FIGURE 1

Step 1:

Attach the Front Stabilizer (54)
onto Main Frame (1) with the
carriage screws (35), cap nuts
(33), and arc washers (34).

Figure 1

FIGURE 2

Step 1:

Attach the rear frame
w/aluminum rails 2 to the
main frame (1) and secure it
with carriage bolts (35), arc
washers (34) and cap nuts
(33).

Figure 2

7