Keys Fitness HT402t User Manual
Owner’s Manual
HEALTH TRAINER 402t TREADMILL
Customer Service
(888) 340-0482
Keys Fitness Products
4009 Distribution Drive
Suite 250
Garland, TX 75041
www.keysfitness.com
Model Name : HT402t
Serial Number :
Purchase Date :
Write down for future reference
Serial Number Decal Location
HT402T
415-00014
09/05 Rev. B
Table of Contents
Important Safety Information 3
Before You Start 4
Assembly 5-7
Warm Up Exercises 8
Moving Instructions 9
Power Requirements 10
Console Panel Functions 11-12
Program and Operation 13
Belt Adjustment 14
Maintenance Instructions 15
Troubleshooting Guide 16
Error Messages 17
Parts List 18
Exploded View 19
Warranty Information 20
2
Important Safety Information
WARNING! Before using this treadmill or starting any exercise program, consult your physician. This is espe-
cially important for persons over the age of 35 and/or persons with pre-existing health problems. The man-
ufacturer or distributor assumes no responsibility for personal injury or property damage sustained by or
through the use of this product.
WARNING! To reduce the risk of electrical shock, burns, fire, or other possible injuries to the user, it is impor-
tant to review this manual and the following precautions before operation.
SAVE THESE INSTRUCTIONS
SAFETY PRECAUTIONS AND TIPS
1. It is the owner’s responsibility to ensure that all users of this treadmill have read the Owner’s Manual and are
familiar with warnings and safety precautions.
2. This treadmill has a user maximum capacity of 225 pounds.
3. The treadmill should only be used on a level surface and is intended for indoor use only. The treadmill
should not be placed in a garage, patio, or near water and should never be used while you are wet. Keys recom-
mends a treadmill mat be placed under the treadmill to protect floor or carpet and for easier cleaning.
4. Follow safety information in regards to plugging in your treadmill. Keep the power cord away from the
incline wheels and do not run the power cord underneath your treadmill. Do not operate the treadmill with a
damaged or frayed power cord.
5. Wear comfortable, good-quality walking or running shoes and appropriate clothing. Do not use the treadmill
with bare feet, sandals, socks or stockings.
6. Always straddle the belt and allow it to start moving before stepping onto the belt.
7. Hold on to handrail when adjusting speed or other controls.
8. Always examine your treadmill before using to ensure all parts are in working order.
9. Allow the belt to fully stop before dismounting.
10. Pets should never be allowed near or on the treadmill.
11. Close supervision is necessary when this appliance is used by or near children, invalids or disabled persons.
12. Never operate the treadmill where oxygen is being administered, or where aerosol products are being used.
13. Never insert any object or body parts into any opening.
14. For safety and to prevent damage to your treadmill, no more than one person should use the treadmill at a
time.
15. Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be per-
formed by an authorized service representative, unless authorized and/or instructed by the manufacturer
16. Failure to follow these instructions will void the treadmill warranty.
17. Never leave the treadmill unattended when plugged in. Unplug from outlet when not in use and before
service or maintenance.
18. Always unplug this appliance immediately after using and before cleaning. To disconnect, turn all controls
to the off position, then remove plug from outlet.
3
Before You Start
Thank you for purchasing the HEALTH TRAINER 402t Treadmill! This quality product you have chosen
was designed to meet your needs for cardiovascular exercise. Before you start, please read the Owner's
Manual and become familiar with the operation of your new treadmill.
Remember to take the time to perform the stretching exercises provided to avoid injury.
Do not stand on the walking belt while pressing the Power button or Start/Stop button.
Always adjust the speed of the treadmill in small increments as this treadmill is capable of high speeds.
If you are taking medication, consult your physician to see if the medication will affect your exercise heart
rate.
If you have heart problems, you are not active, and/or are over the age of 35 years, do not use the pre-set
treadmill programs or start an exercise program without first contacting and receiving approval from your
physician.
To avoid the risk of electrical shock, always keep the console dry. Do not spill liquids on the console. Keys
Fitness recommends a sealed water bottle for beverages consumed while using the treadmill.
Please review the following drawing below to familiarize yourself with the listed parts.
4
CONSOLE
SAFETY KEY
RIGHT UPRIGHT
LEFT UPRIGHT
RUNNING BELT
TRANSPORT WHEEL
MOTOR COVER
LATCH
POWER CORD
END CAPS
BASE
TOP RAIL
Assembly
The HEALTH TRAINER 402t treadmill will require assembly before operating. After opening the box,
remove any packing material from the treadmill.
Do not throw away any packing materials until the unit is working properly.
Place the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.
Locate the hardware pack and identify the following parts required for assembly.
Assembly Parts:
1. Owner’s Manual
2. Console Assembly
3. Left and Right Uprights
4. Top Rail
5. Allen Wrench
6. Arc Washer 10*20*1.5 mm (10)
7. Allen Bolt M8*15 mm (10)
8. Allen Bolts M5*15 mm (4)
5
LEFT UPRIGHT
ALLEN BOLT
M8X15
10PCS
RIGHT UPRIGHT
BASE
ARC WASHER
φ10Xφ20X1.5
10PCS
CONSOLE
TOP RAIL
ALLEN WRENCH
Owber’s Manual
Assembly
Assembly requires the included allen wrench and
your own phillips screwdriver.
Do not plug in the power cord until all assembly
step are completed.
1. With the treadmill deck in the down position,
leave the unit on the original packing material to
assemble all parts.Refer to Figure 1.
6
Figure 1: Deck in down position
Figure 2: Left and Right Upright Installation
Figure 3: Top Rail Grommet Assembly
2. Feed the cable thru the Right Upright until the
connector is exposed.
Install Right Upright to base using 4 Allen Bolts
M8*15mm and Four Arc Washers. Hand tighten all
hardware at this time.
Repeat for Left Upright . Refer to Figure 2.
Note: Be careful not to pinch the wire harness.
3. Use the drag line to pull Console Wire Harness
thru the top rail as shown in Figure 3. Place the
grommet over the Console Wire Harness and install
the grommet in the top rail.
Note: Be careful not to pinch the wire harness.
DRAG LINE
GROMMET
Assembly
7
Figure 4: Top Rail Assembly
4. Attach the top rail to the left and right uprights
using 2 Allen Bolts M5*15 and 2 Arc Washers.
You may now firmly tighten all hardware. Refer to
Figure 4.
Note: Be careful not to pinch the wire harness.
5. Remove the four M5*20mm screws from the back
of the console. Set aside.
Connect Console Wire Harness being careful not to
pinch the wires.
Using four screws previously removed from console,
attach console to the Top Rail. Refer to Figure 5.
CONSOLE
Figure 5: Console Wire Connections
CONGRATULATIONS!!!!!!!!
You have completed assembly of your HealthTrainer 402t Treadmill.
Loading...